Advertisement
Quick Links
Advertisement
Summary of Contents for Jam Q3
- Page 1 Professional Power Amplifier Owner's Manual for model: Q3 /Q7/ Q10/ B8...
- Page 2 SAFETY INSTRUCTIONS AND ADVICE Warning! Please read this user manual fully before using this product, and make sure you follow all the instructions, and heed all warnings. the correct earth/ground pin. Check also the outlet has a Unpack the carton and check the contents to ensure all parts suitable current rating for the equipment.
-
Page 3: Front Panel Controls And Functions
1. Introduction Thank you for your purchase of the Series Power Amplifier. These series amplifiers fully incorporate renown technological expertise, and offer high reliability, rock-solid stability, and superb acoustic characteristics—all in a trim, 1U-sized package. Features: Modular design, each channel is fully separate and without any interference to other channels. Each module is individually fused and has •... - Page 4 1-3 System Connection – four separate channels to four sets of speakers In standard operating mode, you can connect 4 different audio sources, one to each channel (A,B,C or D). Connect speakers to each output channel (A,B,C,D) Use either 2 core cable connected to pin1+ and pin 1- , or 4 core cable where pin2+ and pin 2- are NOT CONNECTED at the speaker end.
- Page 5 1-4 System Connection – bi-amp configuration with 4 core cable Amplifiers are pre-wired with the output for channel B on pin2+/- of channel A output, and also the output from channel D to pin2+/- of channel C output. This is to allow bi-amp configuration without the need of a separate patch panel. Four core speaker cable must be used, and the LF signal applied to input A, and the HF signal applied to input B.
-
Page 6: Start-Up Procedure
2. Operating Instructions 2-3 Troubleshooting: 2-1 Start-up procedure. Indicator(s) Possible cause 1. No power – check there is power, Check all inputs and outputs are connected correctly as per and the power light is on. the above instructions, paying particular attention to the bi- 2. -
Page 7: General Specifications
3. General Specifications Model Number of channels Output Power (All Channels driven output power, THD=1%) 8Ω 350W×4 800W×4 1250W×4 4Ω 500W×4 1400W×4 2350W×4 2Ω 600W×4 1700W×4 2500W×4 Frequency Response (@8Ω) 20Hz-20kHz, ±0.3dB Slew Rate 50V / us THD+N < 0.1% IMD-SMPTE <...