OFM 118-2 Quick Start Manual

Model 118-2 / 118-2-AA / 118-2-DK / 118-2-AA-DK
Parts Listing
A B
Chair Back Chair Seat
1 Unit 1 Unit
C D
Casters Base
1 Unit 1 Unit
E
Seat Mechanism
1 Unit
F G
Telescopic Bellows
Gas Lift
1 Unit 1 Unit
H I
Washer M8x20mm Screw
4 Units 4 Units
A
E
H
I
F
D
WEIGHT CAPACITY: 250 lbs.
Assembly Notes:
During assembly, hand tighten screw. Only when all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this chair as a step ladder.
2. Check for loose screws and tighten them every 6 months.
Assembly Instructions
Tools Needed: Phillips Head Screwdriver
STOP
Please read all instructions before assembly.
Step 1: Insert Casters (C) into Base (D).
If you are assembling a model with a DK Foot Ring please proceed
B STOP
to subsequent pages for drafting kit assembly instructions.
Step 2: Insert Gas Lift (F) into Base (D).
Step 3: Cover Gas Lift (F) with Telescopic Bellows (G).
Step 4: Place Chair Seat (B) on a level surface, and align
Step 5: Please four washers (H) onto four M8x20mm Screws (I),
If you are assembling a model with optional Adjustable Arms please
STOP
proceed to subsequent pages for armrest assembly instructions.
Step 6: Carefully place Chair Seat (B) with attached Seat
G
Step 7: Slide bar on Chair Back (A) into the slot on
Step 8: Hand tighten tension knob on Seat Mechanism (E)
Step 9: Carefully sit on chair to make sure the Gas Lift (F)
C
01.26.18
Posture Task Chair
pre-drilled holes in Seat Mechanism (E) with holes
in bottom of Chair Seat (B).
and insert through the holes in the Seat Mechanism (E)
and into the Chair Seat (B). Tighten screws with scredriver.
Mechanism (E) onto the Gas Lift (F). Press down firmly
on Chair Seat (B) to secure onto Base (D).
Seat Mechanism (E).
until the Chair Back (A) is properly secured.
is properly inserted into the Base (D).
161 Tradition Trail Holly Springs, NC, 27540
800-520-7471 (voice)
919- 303-6389 (voice)
support@ofminc.com
919-362-4765 (fax)
ww w.ofminc.com