Download Print this page

unios Emerald ESPI0005 Quick Start Manual

Spike spotlight

Advertisement

Quick Links

Cleaning
Warning: Before cleaning, disconnect from
mains supply and allow luminaire to cool.
1
2
Disposal
Ensure correct disposal of this
product (waste electrical and
electronic equipment).
Edition 18.5.21 | Product design and technical data may be subject to change
unios.com
Page 4/4
Corrosion Protection
It is important to note that care must be taken
during installation or maintenance to ensure that
the surface of the luminaire is not damaged. Any
damage, which is exposed to moisture will result
in corrosion occurring.
Please also note that any chemical applications on
the luminaire or chemical contact via installation will
cause corrosion of the surface of the luminaire and will
void the warranty.
Ambient Conditions
Recommended to install in an
ambient temperature <35°C.
Emerald
Base
5W
10W
Codes
ESPI0005
ESPI0010
Class III
IP Rating
Material
65
Aluminium
24V DC
CAUTION – This product must be installed by a qualified installer
Please read instruction manual carefully before installing luminaire
Surge Protection
For comprehensive protection of a luminaire against electrical surges, surge protection shall be installed
on the mains supply where required to protect luminaires and drivers from transient voltage damage.
For warranty information visit unios.com/warranty
Please read these installation instructions carefully before installing this product. This product must be installed and
maintained by a suitably qualified person/s in compliance with the latest applicable regulations and relevant legislation.
Unios does not warrant any claim based on defects or damage caused by misuse, improper installation, improper
operation and/or modifications carried out by the purchaser or third parties. This product shall not be used as a
'working light' during construction. This will result in the warranty of the product to be void. For warranty duration,
please refer to the data sheet.
B
C
Edition 18.5.21 | Product design and technical data may be subject to change
Page 1/4
SPIKE SPOTLIGHT
Install Person/s
1x
Sizing Variations
Product Code
A
B
ESPI0005
100
Ø 63
ESPI0010
110
Ø 75
Spike Height
155
All measurements are in millimetres.
Parts
2x Heatshrink
1x Allen Key
Solder Joiners
Additional Accessories
Spotlight Shroud
unios.com
Power
5 | 10 Watts
C
D
78
80
86
92

Advertisement

loading

Summary of Contents for unios Emerald ESPI0005

  • Page 1 Unios does not warrant any claim based on defects or damage caused by misuse, improper installation, improper operation and/or modifications carried out by the purchaser or third parties. This product shall not be used as a 'working light' during construction.
  • Page 2 Page 2/4 Page 3/4 Wiring DRIVER Power Source Spike Surface Mount Installation Installation 240V SELV Strip 7mm Drainage Drainage Hole Hole Heat Heat until tin melts Driver Selection Output Forward Product Code Power Voltage ESPI0005 24V DC ESPI0010 24V DC Dimming This luminaire can not be dimmed.

This manual is also suitable for:

Emerald espi0010