unios Linear Series Quick Start Manual

Wiring Options
Option 1
X
X
X
Product Code Max. single length run (X)
ECM0XX05 20m
ECM0XX10 10m
ECM0XX15 6m
ECM0XX20 5m
ECM0XXFP.15XX.15XX 6.5m
Mounting Guide
GI25, GI40
A B B
Length Hole Qty A
1000mm 3 150mm 350mm
2000mm 5 200mm 400mm
3000mm 6 250mm 500mm
Note: A is the first measurement for both ends.
Edition 21.4.21 | Product design and technical data may be subject to change
Page 4/4
Option 2
A
B
A+B+C= X C
Dimming
For dimming capabilities, luminaire must be paired with
dimmable driver. Please refer to driver's instructions for
pairing of suitable systems.
Disposal
Ensure correct disposal of this
product (waste electrical and
electronic equipment).
Ambient Conditions
Recommended to install in an
ambient temperature <35°C.
GI25T
Corrosion Protection
It is important to note that care must be taken
during installation or maintenance to ensure that
the surface of the luminaire is not damaged. Any
damage, which is exposed to moisture will result
in corrosion occurring.
B
Please also note that any chemical applications on
the luminaire or chemical contact via installation will
cause corrosion of the surface of the luminaire and will
void the warranty.
unios.com
Eclipse G2 Glide 67
Base Glide 67 GI25
Codes
-GI25XX.XX
Class III
24V DC
CAUTION – This product must be installed by a qualified installer
Please read instruction manual carefully before installing luminaire
Surge Protection
For comprehensive protection of a luminaire against electrical surges, surge protection shall be installed
on the mains supply where required to protect luminaires and drivers from transient voltage damage.
For warranty information visit unios.com/warranty
Please read these installation instructions carefully before installing this product. This product must be installed and
maintained by a suitably qualified person/s in compliance with the latest applicable regulations and relevant legislation.
Unios does not warrant any claim based on defects or damage caused by misuse, improper installation, improper
operation and/or modifications carried out by the purchaser or third parties. This product shall not be used as a
'working light' during construction. This will result in the warranty of the product to be void. For warranty duration,
please refer to the data sheet.
Glide67 GI25
24.7
Proper Handling
Ensure not to allow product to bend excessively.
Edition 21.4.21 | Product design and technical data may be subject to change
Glide 67 GI25T Glide 67 GI40 Glide 67 GI40T
-GI25TXX.XX -GI40XX.XX -GI40TXX.XX
IP Rating Material Install Person/s
67 Aluminium 1-2
Glide67 GI25T Glide67 GI40
24.9
40.9
Vertical Installation
1000mm
H
<20mm
unios.com
Page 1/4
LINEAR SERIES
Power
5 ~ 30 Watts
Glide67 GI40T
40
28.6
45
45
1
2