Indiana Paddle & Surf FOIL Manual

INDIANA FOIL – Quick Start Guide
1) Make sure to coat all screws with a thin
layer of Tef-Gel before assembly. This will
prevent corrosion and seizing of the screws.
2) Check your screws before every session
and make sure they are tight.
3) Rinse your foil with fresh water after every use.
4) Check the anodes in the mastplate and the
cartridge regularly. They will degrade after some
time. This is normal. This will happen faster
when the foil is used in salt water. Replace the
anodes if they are broken or cracked.
3) Make sure there is no sand or dirt on the
screws or thread-holes. If there is sand on
the screws you may damage the threads in
the mast.
4) If the frontwing is stuck, or is difficult to
slide onto the fuselage, use a hard rubber
mallet (not included) to loosen the front
wing by hitting the trailing edge near the
center of the wing.
5) We recommend that you take apart the
foil completely if you are not using it for a
long time.
INDIANA WINDFOIL – Quick Start Guide
1) Make sure to coat all screws with a thin layer
of Tef-Gel before assembly. This will prevent
corrosion and seizing of the screws.
2) Check your screws before every session and
make sure they are tight.
3) Rinse your foil with fresh water after every use.
4) Check the anodes in the mastplate and the
cartridge regularly. They will degrade after some
time. This is normal. This will happen faster
when the foil is used in salt water. Replace the
anodes if they are broken or cracked.
3) Make sure there is no sand or dirt on the
screws or thread-holes. If there is sand on the
screws you may damage the threads in the mast.
4) If the frontwing is stuck, or is difficult to slide
onto the fuselage, use a hard rubber mallet (not
included) to loosen the front wing by hitting
the trailing edge near the center of the wing.
5) We recommend that you take apart the foil
completely if you are not using it for a long time.
6) DO NOT insert the Tuttle Head into your
board without the Mast and Plate securely
attched witht the screw as it will be difficult
to remove.
M8 40mm
Slide Wing onto Fuselage
M8 30mm
Front Wing
M8 60mm
M8 Button Head 40mm
Slide Wing onto Fuselage
M8 30mm
Front Wing
M8 60mm
www.indiana-paddlesurf.com
Plate
Mast
Anode
M8 25mm
Cartridge
Stabilizer
Angle Adapter
Fuselage
Tuttle Head
Plate
Mast
Anode
M8 25mm
Cartridge
Stabilizer
Angle Adapter
Fuselage