Advertisement
Quick Links
INSTALLATION INSTRUCTION
®
InvisiLED
CCT 100/200/300/400/600
T24-CS
SAFETY INSTRUCTION
IMPORTANT: NEVER attempt any work without shutting off the electricity.
•
Always turn off power at fuse box prior to installation to prevent electrical shock.
•
Intended for indoor use. Dry and damp locations.
•
For installation and serviced by a qualified, licensed electrician.
•
Install in accordance with national electric code, and local regulations.
•
Consult with local inspector to assure compliance.
•
Do not submerge, or install within 5 feet of a swimming pool.
•
Only install with a WAC UL listed Class 2 24VDC LED power supply.
•
Do not connect the tape directly to high voltage power
•
Do not exceed maximum run recommended for each tape series
•
Do not connect the tape with 24VAC output Electronics transformer.
CAUTION
•
Read all instructions before installing.
•
Handle product with care.
•
Do not modify or disassemble product beyond instructions or warranty will be void.
•
Cutting anywhere other than the cut point will result in a damage to the tape light
•
Failure to follow safety warnings, and installation instruction will void the warranty
•
3-wires are needed for proper operation of
•
Tape light will begin to flash if maximum rated output power from WAC 24VDC CCT power supply is overloaded.
Avoid contact with
sharp objects
Do not cover LED tape light
with any materials
®
InvisiLED
CCT
Install on stable clean,
dry surface
Do not fold or twist LED Tape
Do not bend the tape
light to a diameter less
than 4 inches
Do not power the LED tape
while attached to the spool or
tightly coiled
Do not bend the tape
light on a horizontal
plane
1
Advertisement
Summary of Contents for WAC Lighting InvisiLED CCT 100
- Page 1 INSTALLATION INSTRUCTION ® InvisiLED CCT 100/200/300/400/600 T24-CS SAFETY INSTRUCTION IMPORTANT: NEVER attempt any work without shutting off the electricity. • Always turn off power at fuse box prior to installation to prevent electrical shock. • Intended for indoor use. Dry and damp locations. •...
-
Page 2: Wiring And Installation
WIRING AND INSTALLATION: 1. Turn Power off at circuit breaker 2. Mounting Enclosed 24VDC CCT class 2 output remote power supply at desired location. Measured a distance between power supply to the beginning of the tape run and make sure that it is under 100ft.The allowed maximum distance of wires between the output of power supply to the beginning of tape is 100 ft. - Page 3 3. Measure the desired length of tape light and round it off to the nearest 4-inch interval. Determine necessary quantities of other accessories and power supply need for each run. Do not exceed maximum run recommended for each tape series 4.
- Page 4 Tape to Tape T Connector (T24-TI-WT) Tape to Tape X Connector (T24-XI-WT) Tape to Tape L Connector (T24-LI-WT) Flex Tape to Tape Y Connector (T24-Y-WT, T24-Y-BK)
- Page 5 Flex Tape to Tape X Connector (T24-X-WT, T24-X-BK) 7. Connect electrical power feed connector to any connector on the tape or accessories. There is no polarity. Power feed and connectivity can be done with all directions. Hard Wire: • Enclosed 24VDC CCT class 2 output remote power supply must be installed away from any heat sources and it must be accessible for service.
-
Page 6: System Diagram
SYSTEM DIAGRAM: ON/OFF Switch System TRIAC/ELV Dimmer Control System 0-10V Dimmer Control System CAUTION: WAC CCT Tape light may not be able to dim with other power supply brands. Using only designed power supply to achieve best dimming result.