Advertisement
Quick Links
ASSEMBLY INSTRUCTIONS
Before You Begin:
Please identify all component parts and hardware pieces required before you begin. Carefully remove all of the
components from the packaging and set aside for assembly. Assemble on a soft surface to prevent scratching
during assembly.
Caution:
Tighten all components securely before use. Failure to do so may result in personal injury.
DO NOT use any sharp objects to open plastic wrapped components as damage to product or components may
result.
Warning:
CHOKING HAZARD - Small Parts. Adult Assembly Required.
DO NOT ALLOW CHILDREN TO CLIMB ON FURNITURE
Serious or fatal injuries can occur from furniture tipping over. You must install Tipping Restraint Hardware (where
included) to help prevent the unit from tipping and causing accidental injury, instability, death or damage. The
tipping restraint is intended only as a safety measure, it is not a substitute for proper adult supervision.
To help prevent furniture from tipping over it must be permanently attached to the wall. Anti-Tip Safety Wall
Straps suitable for the unit weight and wall materials (if not included) should be purchased and installed.
Customer Service Email:
CustomerExperience@belnick.com
All-Weather
Polystyrene
Adirondack Chair
| Phone: 866-552-2810
Thank you for your purchase!
Advertisement
Related Manuals for Flash Furniture JJ-C14501-BLU-GG
Summary of Contents for Flash Furniture JJ-C14501-BLU-GG
- Page 1 Thank you for your purchase! All-Weather Polystyrene Adirondack Chair ASSEMBLY INSTRUCTIONS Before You Begin: Please identify all component parts and hardware pieces required before you begin. Carefully remove all of the components from the packaging and set aside for assembly. Assemble on a soft surface to prevent scratching during assembly.
- Page 2 Have a Question/Concern? Quality products and first-class customer service are the cornerstone of long- lasting consumer relationships. We strive toward excellence in all we do and want you to be completely satisfied with your purchase. Please contact our exceptional Customer Experience Agents at the email address or phone number shown below to assist you with any product questions or issues before requesting a return.
-
Page 3: Hardware Included
PARTS Backrest Crossbeam Armrest Seat Rear Seat Slat Back Supports Legs Armrest Hardware Included... - Page 4 STEP 1 Attach the Rear Seat Slat (Part H) to the Seat (Part B) using (2) 3.5*40 Screws (Part AA) and a Phillips Screwdriver (not included). 3.5*40 Screw Seat Rear Seat Slat STEP 2 Attach the Legs (Part F) to the Seat (Part B) using (4) M6*60 Bolts (Part DD). Attach the Back Supports (Part E) to the Seat (Part B) using (4) M6*45 Bolts (Part EE).
- Page 5 STEP 3 Attach the Armrests (Part C) and (Part D) to the Legs (Part F) using (2) M6*60 Bolts (Part DD). Armrest M6*60 Bolt Armrest STEP 4 Attach the Backrest (Part A) to the Seat (Part B) using (2) M6*60 Bolts (Part BB). Attach the Armrests (Part C) and (Part D) to the Backrest (Part A) using (2) M6*70 Bolts (Part CC).