Advertisement
Available languages
Available languages
Quick Links
Please follow these instructions for the correct assembly of your chimenea stand.
The stand has the following components:
1 x Ring
3 x Legs
3 x Hex socket screws
1 x hex key
Assembly is best done by placing all the components on a table.
1.0
Place the ring with the sockets pointing upwards. Pickup a leg and locate
the flat on the straight part. Insert the leg into the socket so that the feet are
pointing inwards.
2.0
Insert one hex socket screw into the threaded hole in the ring leg socket
And tighten using the fingers. Check the feet are pointing inwards and the screw
is contacting the 'flat' on the top of the leg.
3.0
Repeat the above procedure for all three legs. The assembled stand
should now look as shown below-
WARNING: tighten all screws using the hex key, If the screws are not tight
there is a risk of a leg becoming detached and the stand collapsing.
ASSEMBLY INSTRUCTIONS
Chimenea Stands S2 & S3 K/D
Advertisement
Summary of Contents for GARDECO S2 K/D
- Page 1 ASSEMBLY INSTRUCTIONS Chimenea Stands S2 & S3 K/D Please follow these instructions for the correct assembly of your chimenea stand. The stand has the following components: 1 x Ring 3 x Legs 3 x Hex socket screws 1 x hex key Assembly is best done by placing all the components on a table.
- Page 2 INSTRUCTIONS D’ASSEMBLAGE POUR SUPPORTS DE CHEMINEE S2 & S3 K/D SVP suivez-ces instructions pour assembler correctement votre support de cheminée. Voici les composants de votre support : 1 x cercle 3 x pieds 3 x vis six pans 1 x clé six pans L’assemblage est mieux réalisé...