Page 3
Service Manual Disassembly Hydraulic Motor type MM, MLHM Fig. 2 Instructions in this manual are for MM and 5. Remove plate. Remove O-ring from plate MLHM motors. groove (For MM 8 the plate has O-rings from Cleanliness is extremely important when both sides!) Remove balls (2 pcs.) (see Figure 2).
Page 4
Service Manual Disassembly Hydraulic Motor type MM, MLHM Washer Front Cap 1. CLEANING: Wash all parts (except seals) in a weak solvent on carbon base and then degrease. Thrust 2. MEASURING AND REPLACEMENT: Washer Measure all parts and compare actual Housing dimensions with the nominal ones given in the technical documentation.
Page 5
Service Manual Reassembly Hydraulic Motor type MM, MLHM To ensure correct assembling orient motor 8. Install in the front cap 6 screws M6x16 with parts according to previously drawn marking washers and alternately torque them to 8÷10 Nm line. (see Fig.5). 1.
Page 6
Service Manual Reassembly Hydraulic Motor type MM, MLHM mm ball. Lubricate and install O-ring in the 16. Install in the end cover screws with groove of the plate. Install the plate with O-ring washers and alternately torque them to 2,5÷3 side to the cover.
This manual is also suitable for:
Mlhm seriesMlhm 8 c7Mlhm 12.5 c7Mlhm 20 c7Mlhm 32 c7Mlhm 40 c7...
Show all