Advertisement
Quick Links
Advertisement
Related Manuals for M+S MH 2 Series
Summary of Contents for M+S MH 2 Series
- Page 1 SERVICE MANUAL Hydraulic Motors type MH-series 2 and MLHH…B 2008...
- Page 2 Service Manual Hydraulic Motor type MH-series 2, MLHH…B - 2 -...
- Page 3 Service Manual Disassembly Hydraulic Motor type MH-series 2, MLHH…B Instructions in this manual are for MH-series 2 and MLHH…B motors. Cleanliness is extremely important when repairing these motors. Work in clean area! Before disassembly, drain oil from motor. Remove castellated nut, washer and key when used.
- Page 4 Service Manual Disassembly Hydraulic Motor type MH-series 2, MLHH…B 10. Remove with screwdriver Dust seal and Shaft seal from flange (see Figure 5). Work from outer side for both seals. 11. Remove shaft from housing. Fig.6 12. Remove thrust washer and needle bearing from shaft (see Fig.6).
- Page 5 Service Manual Reassembly Hydraulic Motor type MH-series 2, MLHH…B 1. Lubricate output shaft with hydraulic oil 9. Install dust seal in flange. Carefully press (see Fig.6). dust seal into place. Lips of shaft seal and dust seal must face outward. Important: Check seal...
- Page 6 Service Manual Reassembly Hydraulic Motor type MH-series 2, MLHH…B 16. Install distributor plate on housing. Remember which bolt hole was aligned with the shaft timing dot. 17. Lubricate O-rings (2 pcs.) and place them in seal grooves of both stator sides. (see Fig.2).