Ideal Warehouse AutoStand Plus Operation Manual

Important notes:
Only trained and authorized individuals should use this product.
•
• When the AutoStand Plus is first received, the tires must be attached. Slide each tire over each axle,
place washer on,
insert cotter pin
and use pliers to
bend the ends of
the cotter pin to
prevent it from
falling out.
• Use only original Ideal Warehouse Innovations parts to service this product.
• Do not maneuver on steep surfaces; use only on stable, flat surfaces.
Make sure wheels are not in contact with ground during loading process.
•
Use caution in heavy rain, snow or wet environments.
•
Before you begin:
• Complete a visual inspection of the AutoStand Plus for any obvious maintenance issues.
• Be careful moving around the loading dock area to ensure it is safe to move around the area.
• Use appropriate personal protective equipment such as gloves, safety glasses, safety vest, hearing
protection and protective shoes.
AutoStand_Plus_Manual_US-EN_2021-04
AutoStand Plus Trailer Stand
Operation Manual
Original Instructions
Step 1:
Position AutoStand Plus under nose of trailer centered from
both sides, ensuring the stand is positioned approximately in
the center of the trailer, 3 inches (8cm) to 6 inches (16 cm)
deep, under the nose.
Step 2:
Step on the foot plate and press down firmly. You will release
pressure on the locking pin mechanism. This will allow you to
release the spring-biased locking mechanism.
Step 3:
To release the spring biased locking mechanism; push forward
on the hand lever while pressing down on the foot plate. This
will allow the AutoStand Plus to rise to the underside of the
trailer.
Product intended to prevent trailer
up-ending and landing gear collapse
by shouldering the weight in heavy-
duty loading dock environments.
1-866-828-6737 idealwarehouse.com 2021-04-27