F/S Manufacturing DANDY-LION KILLER Instruction Manual

Your 72 inch Dandelion Killer Should Contain:
a
b
a. (1) Tank
b. (2) Rollers
c. (2) Manifolds
l
d. (2) Tires
g
e. (1) Hardware Pack
h
f. (1) Hitch
g. (1) Mounting Frame
h. (1) Left Side Lift Arm
i. (1) Right Side Lift Arm
d
j. (1) Drag Link
k. (1) Right Roller Arm
l. (1) Left Roller Arm
m. (2) Manifold Links j
(Identical)
Hardware Pack Contents
n. (1) Shock Cylinder
o. (4) 5/16" x 1/2" Flange Bolts
p. (2) #4 Band Clamps
q. (10) 5/16" x 1" Bolts
r. (10) 5/16" Nuts
s. (8) 5/16" Flat Washers
t. (2) 5/8" Lock Nuts
u. (3) 1/2" Lock Nuts
o
v. (1) 1/2" x 1 1/4" Bolt
w. (2) 1/2" Washers
x. (1) Valve Assembly (Pre-
q
assembled) r
•
(1) 1/2" Micro Valve
•
(2) 1/2" Street Elbows
s
y. (1) Manifold Supply
Assembly
z
z. (2) Axle Bushings
2
Tools Needed: Ratchet Wrench | 1/2" Socket | 15/16" Socket | 3/4" Socket (or Combination
Wrench) | Flat head screwdriver or 1/4" Nut Driver | 1/2" Combination Wrench
c
k
i
f
e
m
Step 1
1. INSTALL FRAME ON TANK: (Make sure the "decal side" of the tank is opposite the hitch side
of the frame - See Cover Page.) This step uses the (4) 5/16" x 1/2" Flange Bolts.
n
p
t
x
v
u
Step 2
w
2. INSTALL ROLLER ARMS: Slide Roller Arms into both ends of the receiving tube on frame
y
as shown in Image 2. Install one 5/16" Nut on each of four 5/16" x 1" Bolts and loosely
install them into the welded nuts on the frame as shown in Image 3. (Do not tighten yet.)
Setup Instructions:
3
Steps 3 & 4
3. INSTALL VALVE ASSEMBLY & TUBING: First, thread the Valve Assembly on to the Tru-
Kleen male snout on the tank, then thread the Manifold Supply Assembly into the 1/2"
Street Elbow on the Valve Assembly as shown above. (Do not over-tighten!)
4. INSTALL SHOCK CYLINDER & DRAG LINK: As shown above, fasten the shock cylinder
to the Mounting Frame with the quick connect pin shown at top left. Next, connect
other pin from shock cylinder into Drag Link and fasten opposite end of the Drag Link
to Mounting Frame using the 1/2" x 1 1/4" Bolt and 1/2" Lock Nut.
5. INSTALL ROLLERS: Slide rollers onto receiver
pins on Arms and Drag Link as indicated
Step 5
above. (Do not tighten set bolts yet.)
4