Advertisement
Quick Links
Versa series cabinet instructions
1) using #1 and #2 there are pre-drilled holes. using the holes form a T
2) using #3 there are pre-drilled holes. fit the T onto the bottom side of the #3 panel
3) using #4,5,6 and the CX14 screws. screw them on the back of the bottom panel
Advertisement
Summary of Contents for CAD Lights Aquariums Versa Series
- Page 1 Versa series cabinet instructions 1) using #1 and #2 there are pre-drilled holes. using the holes form a T 2) using #3 there are pre-drilled holes. fit the T onto the bottom side of the #3 panel 3) using #4,5,6 and the CX14 screws. screw them on the back of the bottom panel...
- Page 2 4) Using #7,8 place on the left and right sides of the now partially formed bottom of the cabinet. using the CX14 screws, screw in from the outside into the bottom using the pre-drilled holes 5) using #9 put into place in between #7 and #8 towards the upper front corner, then use C screws to screw in from the outside pre-drilled holes to fasten into place 6) using #10, flip upside down and use A anchor rods to screw into the pre-drilled holes 7) when A anchor rods are all in place on the underside of the top panel #10 flip upside down and fit into pre-driled holes of the top of the...
- Page 4 Plumbing set-up: 1) (#1) Durso drain pipe assembly. Unscrew the fastener nut from the bottom of the bulk-head fitting. Make sure the rubber gasket is in place against the Flange of the bulk-head fitting. Slide the entire Durso drain pipe from the top of the aquarium and through the larger drain hole of the tank.