Performance Machine Vision Series Assembly Instructions

BLADE
ARROW
PE PERF PERFORMANCE MACHINE LIMITED WARRANTY INFORMATION RFOR ORMA MANC NCE E MA MACH CHIN INE E LI LIMI MITE TED D W W W W W W AR ARRA
Performance Machine warrants to the original purchaser that the parts of these Vision mirrors to Performance Machine warrants to the original purchaser that the parts of these Vision mirrors to
be free of manufacturing defects in materials and workmanship for a period of one (1) year from the
date of purchase. In the event warranty service is required, you must call Performance Machine
immediately with a description of the problem.
If it is deemed necessary for Performance Machine to make an evaluation to determine whether the
part is defective, a return authorization number will be given by Performance Machine. The parts must
be packaged properly so as to not cause further damage and returned prepaid to Performance Machine
with a copy of the original invoice of purchase and a detailed letter outlining the nature of the problem.
If after the evaluation by Performance Machine the part was found to be defective it will be repaired or
replaced at no cost to you. If we replace it, we may replace it with a reconditioned one of the same
design.
Performance Machine shall not be held liable for any consequential or incidental damages resulting
from the failure of a Performance Machine part.
Performance Machine shall have no obligation if a part becomes defective as a result of improper
installation or abuse.
For questions pertaining to the installation of this product, please contact our technical department at 1-800-479-4037
V VISION SERIES MIRRORS V I I S S I I O O N N S S E E R R I I E E S S M I M I R R R
ROUND
ARROW XL
OVAL
RAN N T T Y Y IN INFO FORM RMA A A A A A TI TION ON
ASSEMBLY INSTRUCTIONS
R O O R R S S PM PM VISION MIRROR INSTALLATION
1. 1. Remove the factory mirrors from the hand controls.
Models may vary so consult the factory service manual for specific instrucions.
2. Install the PM Vision mirror using the supplied stem spacer (1) and 5/16-18 x 2.25" socket head bolt (2).
If reduced height is desired do not install the stem spacer and use the 5/16-18x1.5" socket head bolt (3).
Leave the bolt loose until correct position is achieved. Use blue loctite on the bolt threads.
Note: PM Vision mirrors are universal and can be used for left or right applications. To convert the Vision
mirror to left or right application simply rotate the mirror head (5) 180 degrees.
3. 3. While sitting on the bike position the mirror to give the best range of view and snug the bolt using a
1/4" hex wrench. Torque the socket head bolt to 10 ft-lbs.
4. 4. Go for a ride!
0048-0909 REVISION A 10/19/12
FIG A: COMPONENTS
5
4
3
1
2
FRONT
PAGE 1