Advertisement
Quick Links
Specification of KL180-4 KL180-2 KL180C-4 KL180D-4
KL180E-4
Parameter:
Working Voltage：DC12V
Working Current：10mA
Frequency：433.92MHz
Modulation：ASK
Temperature：-20-55℃
Dimension：55*30*13.5mm
Weight : 28.2g
Encode type: Learning code
Operation Method:
1. Match code:
Hold learning button and learning indicator light blinks, then press any buttons of remote control,
if indicator lights flashes 3 times, match code successfully. Maximum 80 remote controls can be
matched.
2. Delete code:
Hold learning button till the indicator LED lights and then off, delete successfully.
3. Set working mode:
S1 & S2 program the sequence as follows:
Jumper on S1→ Toggle
Jumper on S2→ Latched
No Jumper on S1 &S2→ Momentary
Advertisement
Summary of Contents for Kelvin Electronics KL180-2
- Page 1 Specification of KL180-4 KL180-2 KL180C-4 KL180D-4 KL180E-4 Parameter: Working Voltage：DC12V Working Current：10mA Frequency：433.92MHz Modulation：ASK Temperature：-20-55℃ Dimension：55*30*13.5mm Weight : 28.2g Encode type: Learning code Operation Method: 1. Match code: Hold learning button and learning indicator light blinks, then press any buttons of remote control, if indicator lights flashes 3 times, match code successfully.
- Page 2 Working Mode: 1. Non-lock/Momentary: Press remote button A, the corresponding relay on the receiver is on; release button A, the relay is off, the same as others. 2. Self-lock/Toggle: Press remote button A, the corresponding relay on the receiver is on; press button A again, the relay is off, the same as others.
- Page 3 Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.