Download Print this page

Makey Makey Makey Go How To Use

Download this manual

Makey Go, How to use:

1) Plug in USB

The lights on the GO will dance a little, then settle on Blue.

Blue = Right Click.

2) Close Popup Window (If Any)

Your computer may ask you to install drivers or do other setup. You can click cancel

or close the window.

3) Connect your object

Connect the alligator clip from your object to the Plus Sensor

Page 1 Makey Go, How to use: 1) Plug in USB The lights on the GO will dance a little, then settle on Blue. Blue = Right Click. 2) Close Popup Window (If Any) Your computer may ask you to install drivers or do other setup. You can click cancel or close the window.
Page 2 4) Press Play Tap the Play Button . The GO has now recalibrated itself to accept the object. 5) Play! Now you can use your clemintine to click on things! Tap your clemintine and see what happens. 6) Space Out...
Page 3 Say you've got a big pot, and you tap play, and then you tap the pot, but Makey Makey GO can't tell you're touching the pot (the light doesn't turn green). This is a good time to try the sensitive setting.
Page 4: Troubleshooting
Make sure your Makey Makey GO is plugged into the computer.  The Makey Makey GO should have a red or blue light on the back showing that it is connected properly. Is it lit? If there's no light, something is wrong with the computer or the GO.
Page 5  Try tapping the Play Button  Try unplugging the Makey Makey GO from your computer, then plug it back in again.  If the object connected to the Makey Makey GO is your own body, then perhaps you are sending a connection by touching your computer's metal case, or by not wearing shoes.

4016139183565