Advertisement
Quick Links
Cable Manager Locking Details
4. After positioning the cable manager
into the table cut-out, insert the
mounting clamp into the enclosure
for securing the unit to the table surface
(on both sides)
After installing the cable manager on the table
Ensure the mounting clamps has been assembled
as per the above instruction (on both sides)
www.logicav.in
5. Softly tighten the screw to secure
the enclosure towards the bottom
side of the table (on both sides)
Surface
Table
Bottom
INSTALLATION MANUAL
CABLE MANAGER
MODEL
SERIES
LC-403
CABLE CUBBY SERIES
www.logicav.in
Advertisement
Related Manuals for Logic CABLE CUBBY Series
Summary of Contents for Logic CABLE CUBBY Series
- Page 1 (on both sides) After installing the cable manager on the table Surface Table Bottom MODEL SERIES LC-403 CABLE CUBBY SERIES Ensure the mounting clamps has been assembled as per the above instruction (on both sides) www.logicav.in www.logicav.in...
- Page 2 Checklist 2. Installation Instructions to provision the cut-out on the table: ATTENTION: The cut-out on the table for the cable cubby should be executed only by an experienced craftsperson to prevent any damage/ scarring. CAUTION : Wear safety glasses while operating power equipment. Failure to comply may result in eye injury Cable Manager x 1 A: Cut-out template x1...