Advertisement
Quick Links
Nocturne Obelisk 6'
This Obelisk makes a striking statement with its aged
bronze finish on the outside and brass foil finish on the
inside. It's perfect for supporting your favorite annual and
perennial vines.
Parts List
(1) Top Section
(3) Tier
(3) Rings
(3) Bolts
(3) Cap Nuts
(4) Stakes
NOTE: Assembly is easiest with two people.
Step 1. We recommend assembling your Obelisk where
you intend to install it. Select a location that is protected
from high winds and is away from children's play
areas. NOTE: The Obelisk must be installed in firm
soil. If you have loose or sandy soil, we recommend
securing it in concrete.
Step 2. Place a Tier in your chosen spot and press the
hollow ends into the ground to mark their
locations. Move the Tier to the side and
use your rubber mallet to gently pound
the Stakes into the marked spots. Slide the
hollow ends of the Tier over the tops of the
Stakes.
Step 3. Slide the loops inside of a Ring over
the pronged ends of the Tier from Step 2.
Slide the loose end of the ribbon under the
Ring, lining up the holes in the ribbon and
the nearest upright. (Figure 2). Place a Bolt
through the set of holes and screw a Cap
Nut onto the end of it.
#8597445
Tools needed
Phillips Screwdriver
Rubber Mallet
Assembly
over please
Figure 1
Figure 2
Cap Nut
ribbon
Top Section
Ring
Tier
Ring
Tier
Ring
Tier
Stakes
Ring
Bolt
upright
with hole
Tier
1198V Rev 11/18
Advertisement
Summary of Contents for Gardener's Nocturne Obelisk
- Page 1 Nocturne Obelisk 6’ Figure 1 Top Section This Obelisk makes a striking statement with its aged bronze finish on the outside and brass foil finish on the inside. It's perfect for supporting your favorite annual and perennial vines. Parts List...
- Page 2 Step 4. Slide the hollow ends of another Tier over the pronged ends of the first one, making sure to line up the ribbon as shown in Figure 1 (other side). Step 5. Repeat Steps 3-4 to attach and assemble the remaining Tiers. Step 6.