Advertisement
Quick Links
INSTALLATION
INSTRUCTIONS
FOR PX SERIES
WORK LAMP KIT
1. PACKING LIST & ACTUAL IMAGE
2. GENERAL SAFETy INFORMATION
3. INSTALLATION INSTRUCTION
D.D KIT#. TG15-A0003B
TG120_07_작업등키트_영문-A4.indd 1
Koerilenstraat 2, 399LR, Maasvlakte-Rotterdam The Netherlands
SERVICE SUPPORT DIVISION / DAEDONG INDUSTRIAL Co.,Ltd.
35, Nongongjungang-ro 34-gil Nongong-eup, Dalseong-gun, Daegu, KOREA 42984
- -
KIOTI TRACTOR DIVISION / DAEDONG-USA, Inc.
6300 Kioti Dr. Wendell, NC 2759
Toll Free:1877-GO-KIOTI
Tel:-99-374-500 Fax:-99-374-500
http://www.kioti.com
DAEDONG KIOTI EUROPE B.V
Tel:+3 (0)8 35 30 25
http://www.kioti.eu
Tel:82-53-60-3350 Fax:82-53-60-3359
http://www.daedong.co.kr
Printed in Korea. JUN.206
2016-07-04 오전 8:34:28
Advertisement
Summary of Contents for Daedong PX Series
- Page 1 DAEDONG KIOTI EUROPE B.V Koerilenstraat 2, 399LR, Maasvlakte-Rotterdam The Netherlands Tel:+3 (0)8 35 30 25 http://www.kioti.eu SERVICE SUPPORT DIVISION / DAEDONG INDUSTRIAL Co.,Ltd. 35, Nongongjungang-ro 34-gil Nongong-eup, Dalseong-gun, Daegu, KOREA 42984 Tel:82-53-60-3350 Fax:82-53-60-3359 http://www.daedong.co.kr - - Printed in Korea. JUN.206 TG120_07_작업등키트_영문-A4.indd 1...
- Page 2 1. PACKING LIST & ACTUAL IMAGE Part No. Description Q'Ty Remark TG5-002A REAR WORK LAMP ASS'Y T4625-5543 FLANGE BOLT T530-69802 SIDE WORK LAMP(LED) ASS'Y 02763-50080 FLANGE NUT TG6-0226A BRACKET(LH), WORK LAMP TG6-0227A BRACKET(RH), WORK LAMP 0023-50660 BOLT, WASHER ATTACH T4680-932 CAP NUT, M6 TG2A701C - 2 -...
- Page 3 2. GENERAL SAFETy INFORMATION This symbol means ATTENTION! yOUR SAFETy IS INVOLVED. The message that follows the symbol contains important information about safety. Carefully read the message. BEFORE SERVICING AND REPAIRING . Read all safety instruction in this manual and be aware of safety decal locations on your machine. 2.
- Page 4 REMARKS • Be sure to remain enough length of wire outside of the pillar before tighten it so that lamp angle can be adjusted freely. TG2A704A TG2A710A 4. Pass the LED work lamp assembly wiring, which was assembled in Step 3, through the pillar cover hole (A) to connect it to the wiring connector on the vehicle body.