OFM Mesa Series Assembly Instructions

Model 66366
Parts Listing
A
Desk Top
1 Unit
B C
Side Panel Legs Pedestal
1 Unit
2 Units
D E F
Privacy Panel Drawer Runners Drawer
1 Unit 2 Units 1 Unit
G H I
6x55mm Screw 10x35mm Screw 6x16mm Screw
4 Units 4 Units 12 Units
L
J K
Allen Wrench Phillips Head Corner
1 Unit Screw Bit Leg Bracket
1 Unit 4 Units
Mesa Series Single Pedestal Desk
1
B
L
H
J
A
E
E
I
3
I
Assembly Notes:
During assembly, hand tighten screws only. When all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this desk as a step ladder.
2. Check for loose screws and tighten them every 6 months.
Assembly Instructions
Tools Needed: Phillips Head Screwdriver
STOP
Please read all instructions before assembly. Assembly will require 2 people.
The following instructions result in a 66366L-ready desk. For a 66366R, please
assemble Pedestal on opposite side.
Step 1: Align Side Panel Legs (B) with the support rail on the underside of the Desk Top (A).
Place Corner Leg Bracket (L) in holes on support rail, and insert 10x35mm Screw (H)
through bracket and into legs. Tighten using Allen Wrench (J). Align Drawer
Runners (E) with holes in underside of the Desk Top (A). Attach using 6x16mm
Screws (I) and Phillips Head Screw Bit (K).
Step 2: Attach Pedestal (C) to underside of Desk Top (A) by aligning screw holes in
Pedestal with holes in Desk Top, and inserting 6x55mm Screws (G) to secure.
Tighten using Phillips Head Screw Bit (K) or screwdriver.
Step 3: Attach Pedestal (C) to Side Panel Legs (B) by inserting
2
G
Step 4: Attach Privacy Panel (D) to Pedestal (C) by inserting 6x16mm
B
C
Step 5: Flip the desk right side up using at least two people. Insert the
A
4 5
I
K
D
C
01.16.2014
6x16mm Screws (I) through pedestal wall and into legs.
Tighten using Phillips Head Screw Bit (K) or screwdriver.
Screws (I) through side of Privacy Panel (D) and into the side of
Pedestal (C). Attach Privacy Panel (D) to Side Panel Legs (B)
by inserting 6x16mm Screws (I) through other side of Privacy
Panel (D) and into the corresponding hole on the inside of the
Side Panel Leg (B). Tighten using Phillips Head Screw Bit (K).
Drawer (F) backwards, as shown, aligning it with the
Drawer Runners (E). Push Drawer (F) all the way in to secure.
STOP If you have Model 66366R or 66366L, please proceed to next
page for Return assembly.
F
161 Tradition Trail, Holly Springs, NC, 27540
800-520-7471 (voice)
919-303-6389 (voice)
support@ofminc.com
919-362-4765 (fax)
www.ofminc.com