Page 1
Manual for motor FM 60 / 70 s1-FS ( Date of publication 06/2016) Manual for motor FM 60 s1-FS / FM 70 s1-FS Safety instructions. It is imperative that you read before handling and using the motor this notice and study the motor manual.
Page 2
Manual for motor FM 60 / 70 s1-FS ( Date of publication 06/2016) Please take great care in securing the motor in model and check it regularly. Likewise, check the propeler mounting screw. It is not allowed to move when the engine is running in the plane of rotation of the propeller and in front of it (in the case of classical, towing arrangement - CW).
Page 3
Manual for motor FM 60 / 70 s1-FS ( Date of publication 06/2016) 2. Description of the motor It is a 4-stroke motor with OHV and 2 valves per cylinder. Microprocessor ignition for easy starting and smooth running in all modes of engine speed. 3.
Page 4
Manual for motor FM 60 / 70 s1-FS ( Date of publication 06/2016) Note : ignition is equipped with a security protection function, because if it is turned on and the motor is more than a minute at rest, the ignition is switched off. In this case, it is only the ignition off and on again.
Page 5
Manual for motor FM 60 / 70 s1-FS ( Date of publication 06/2016) If a situation arises that the engine will not start, there was either a glut motor fuel, or vice versa engine is lean. Because these conditions can be difficult to detect, we recommend the following procedure: - Check the fuel system (leaks, throughput, level of fuel etc.).
Manual for motor FM 60 / 70 s1-FS ( Date of publication 06/2016) 8. Install the motor inside the model When thinking about the placement of the engine into the model, keep in mind that it is absolutely necessary to ensure proper cooling. Use the 4 screws to attach the motor to the motor mount. Engine mount directly without dampers.
Page 7
Manual for motor FM 60 / 70 s1-FS ( Date of publication 06/2016) At the same time, or at least from time to time it is necessary to check the cleanliness of the motor, status / battery condition for ignition and the gap between the spark plug electrodes. This should be set to 0.4 mm.