Universal Furniture 393678 Instruction Sheet

393/394678
Thank you for purchasing this quality product. Be sure to check all packing material carefully for small
parts that may have come loose inside the carton during shipment.
Caution: (1) These parts are cumbersome and heavy. This product can best be assembled with the
assistance of one or more persons in order to prevent personal injury and to insure parts are not damaged
during the assembly process. If dirty, clean finished parts with mild dishwashing liquid and water solution
applied on damp cloth. Cloth should not be excessively wet. Polish finish with soft cloth and an industry
recognized furniture polish.
(2) To prevent damage to your floor or carpet, please check the bottom of each piece of furniture for
stain residue and rough surfaces and also check for staples or nails left after removing the packaging material.
The manufacturer will not be held responsible if preventative steps are not taken prior to installation.
(3) Unpack and dispose of all packing material but be careful not to throw away any assembly parts or
hardware. Read the instruction sheet and parts list carefully. Remove all staples and screws used for
packaging carefully using pliers and or screwdrivers to prevent injury and scratching or damaging flooring.
(4) During normal use everyday, screws, bolts, nuts and wooden plugs may loosen up. They should be
periodically inspected and re-tightened to prevent damage to the furniture and (or) personal property or cause
injury. Always check to be sure all hardware on this list and the above mentioned components is attached to
the furniture properly and kept tightened at all times.
PARTS LIST:
# Description
A Side Post
C Bottom Shelf
E Hardware Pack
Assembly Procedure
Step 1: Unpack, inspect, and read assembly instruction carefully. Lay out the parts and hardware.
Make sure the quantity of each is correct.
Step 2: Insert the wood dowels (6) into the predrilled holes on the side posts (A), then attach the
shelves (B) to the side posts (A) with allen head bolts (1), spring washers (2) and flat
washers (3) from hardware pack (E) using allen wrench (7). Note: Donot over tighten. Next,
lay it down, then attach the bottom shelf (C) to the side posts (A) with phillip head bolts (5),
spring washers (2) and flat washers (3) from hardware pack (E) using wrench (4), then
tighten all bolts.
Step 3: Turn it upright. Put the decorative covers (D) onto the holes of side posts (A).
Note: It is recommended assembled by two people.
Assembly is now complete.
INSTRUCTION SHEET
Qty. #
2pcs B
1pc D
1bag
: (Please follow the sketches below.)
HARDWARE PACK (E)
ALLEN HEAD
BOLT
SPRING
WASHER
FLAT
WASHER
WRENCH
PHILLIP
HEAD BOLT
WOOD
DOWEL
ALLEN
WRENCH
GOOD, AFFORDABLE, SMART DESIGN.
Pantry Rack
Description
Shelf
Decorative cover
Qty.
4pcs
8pcs