SS-TH1000 ½" THERMOSTATIC VALVE
SS-TH2000 ½" THERMOSTATIC VALVE WITH
BUILT IN VOLUME CONTROL
Features:
Ability to pre-select water temperature – thus conserving water
Compensates for water pressure fluctuations preventing scalding
Safety button at 100°F prevents accidental scalding
High flow rates allow for multiple shower applications
Listed by IAPMO, CSA, NSF, and other municipalities
Specifications:
o Operating pressure is 20 PSI to 72 PSI
o When pressure is higher than 72 PSI a pressure reducer (fitted before the valve) is required.
o Temperature range is 50°F to 180°F
o Recommended setting is 29 PSI and 149°F
Note:
DO NOT USE PLUMBER'S PUTTY ON ANY OF THE BRASS COMPONENTS
This will cause the finish to tarnish and void the warranty. A non-corrosive Alkoxy Silicone is
recommended.
DURING SWEATING OF LINES DO NOT OVERHEAT CASTING
Overheating may cause damage to internal mechanism and void the manufacturer's warranty as
well as increase the risk of scalding.
COPPER ADAPTORS MAY BE REQUIRED TO COMPLETE YOUR INSTALLATION
Shipping weight: 4 lb (SS-TH1000/3000) or 5 lb (SS-TH2000/4000)
Shipping dimension: 7"x7"x3.5" (SS-TH1000/3000) or 8"x7.5"x6" (SS-TH2000/4000)
Note:
Separate wall stops/shut off valves/volume controls (SS-TS150 or SS-TS200) may be needed in
conjunction with this valve. A thermostatic valve's only function is to mix temperature.
SS-TH3000 ¾" THERMOSTATIC VALVE
SS-TH4000 ¾" THERMOSTATIC VALVE WITH
Diagram 1: Flow Rate Vs. Pressure
INSTALLTION FOR
THERMOSTATIC VALVES
BUILT IN VOLUME CONTROL
Rev. 10/17
P a g e
| 1