ACSI 1000 Series Installation Instructions

ELE
Electrical Input Requirements:
Filtered and Regulated Power Supply
Voltage: 24VDC 10%
Current: 1A MAX Inrush, 400mA MAX Holding
Non-polarized Leads
RO IDE IM L A EO
Installation:
1. Separate the mechanism case from the baseplate assembly.
2. Remove the manual dogging assembly, if present, from the baseplate assembly and discard.
3. Skip to step 11 if installing in a 33" device or a 42" device with an 18" push bar.
4. Separate the push bar from the baseplate assembly by removing the lower push bar mounting pins.
5. Separate the front push bar end cap from the push bar.
6. Slide the push bar cover forward to expose the rear push bar end cap mounting screws.
7. Replace the rear push bar end cap mounting screws one at a time with the supplied screws to maintain the
correct position of the end cap.
8. Attach the supplied connecting bracket with connecting pin installed using the supplied locknut.
9. Slide the push bar cover back to the original position and attach the front push bar end cap to the push bar.
10. Attach the push bar to the baseplate assembly using the lower push bar mounting pins.
11. Locate the 1550K-MDH Kit near the holes that secured the manual dogging assembly.
12. Attach the connecting link to the installed connecting bracket and pin for the 42" device with 24" push bar or
the rear mechanism of the push bar for the 33" device or for the 42" device with 18" push bar.
13. Attach the motor bracket to the baseplate assembly using the supplied screws and lockwashers through the
holes that secured the manual dogging assembly.
14. Attach the mechanism case to the baseplate assembly.
15. Install the ratchet clip into the mechanical dogging hole of the slide cover.
16. Apply the supplied technical assistance labels to the head cover and the end cover.
Do not remove an regulator labels adhered to the device
DE I E
REAR PUSH BAR
END CAP
SUPPLIED LOCKNUT
BASEPLATE ASSEMBLY
2720 CLARK AVE. ~ ST. LOUIS, MO 63103 ~ 1-800-753-5558 ~ www.acsi-inc.com
RI E I DE I E I I
MO OR DRI E ELE
DESIGN HARDWARE 1000 SERIES
ELE RI LA
MECHANISM CASE
SUPPLIED SCREWS
AR
SUPPLIED CONNECTING PIN
SUPPLIED CONNECTING BRACKET
LOWER PUSH BAR MOUNTING PINS
ALLA IO I
RI LA
MD
RE RA IO A D DO
RATCHET CLIP
R
RE RA IO
Allo able uto rom Device Length
tandard
1.50"
I AR DE RE ED
onductor
Distance
70'
110'
180'
280'
450'
720'
FRONT PUSH BAR
END CAP
END CAP SCREWS
IO
tandard
4.25"
ire Run
ire auge
22
20
18
16
14
12
PUSH BAR
COVER
II-E1500-39
REV. 10/2019