Advertisement
Quick Links
Instructions for Use
Pro 5 – Pro 8 – Pro 10
Oxygen Generators
For models: 625, 725, 685, 785, 695 and 795 (and
variants thereof)
This device supplies highly concentrated oxygen
enriched product gas that promotes rapid
burning.
DO NOT allow smoking or open flames within the
same room of this device.
Failure to observe this warning can result in
severe fire, property damage, and / or cause
physical injury or death.
Oxygen accelerates the combustion of flammable
substances.
DO NOT use oil, grease, petroleum based or other
flammable products on the device.
This device is intended for industrial use. It
should be placed in a well-ventilated area, free
from smoke and atmospheric pollution, where
the intake filter ventilation is not obstructed or
blocked.
DO NOT use in an explosive environment.
DO NOT use in a magnetic environment.
ON (Power switched on)
OFF (Power switched off)
Class I (Protective Earth)
Do Not Expose to Open
Flames
Do Not Expose to Oil or
Grease
2010-2339NM Rev A
1
Glossary of Symbols
Tools Required /
Technician Only
FRAGILE – Handle with
Care
Keep in Vertical Position
Protection from vertically
IPX1
falling water drops
17 July 2018
DO NOT open the device while in operation.
Failure to observe this warning can result in
electrical shock.
DO NOT remove the cabinets unless you are a
qualified service technician.
DO NOT use extension cords or adapters. Use the
power cord provided.
Check that the electrical characteristics of the
power outlet used match those indicated on the
manufacturer's plate on the rear panel of the
device.
This unit may be equipped with a polarized plug.
That is one blade wider than the other. If it does
not fit into the outlet, reverse the plug. If it still
does not fit, contact a qualified electrician. Do not
defeat this safety feature.
Only persons who have read and understood this
entire manual should be allowed to operate the
device.
WARNING – A hazard or unsafe
practice that can result in serious
injury or death if conditions are
not avoided.
Caution - A hazard or unsafe
practice that can result in minor
injury and / or property damage if
conditions are not avoided.
Note – Information important
enough to emphasize or repeat
Page 1 of 4
Advertisement
Related Manuals for Pro2 625
Summary of Contents for Pro2 625
- Page 1 Instructions for Use Pro 5 – Pro 8 – Pro 10 Oxygen Generators For models: 625, 725, 685, 785, 695 and 795 (and variants thereof) DO NOT open the device while in operation. This device supplies highly concentrated oxygen Failure to observe this warning can result in enriched product gas that promotes rapid electrical shock.
- Page 2 Purpose and Principles of Operation This device is intended to supply oxygen for applications requiring high concentration. It produces an enriched product gas by concentrating the oxygen contained in room air. The operation of the device begins with air being pulled into the external air intake filter. This filtered air enters the compressor via a suction resonator and fine filter.
- Page 3 To use your device safely, follow the directions below. Ensure that the Power Switch (1) is in the “O” (OFF) position. Ensure the Intake Ventilation (7) is not obstructed or blocked. Plug the Power Cord (9) into an outlet of the correct voltage and frequency as defined on the Technical Label (8).
- Page 4 Storage and Operating Conditions The device should be stored in a dry area, with an ambient temperature between -20°C to 60°C (0°F to 140°F) at 15- 95% relative humidity. It must be stored, transported and used in the vertical position only. Oxygen concentration can be affected after prolonged periods of storage –...