Kelkay Easy Fountain 45011L Quick Start Manual

Easy Fountain Instructions
45011L - Pebble Birdbath
Please read the assembly and pump operating instructions carefully and observe the safety
instructions.
STAGE 1
Position the base section of the feature onto a secure and level location.
STAGE 2
Following the diagram above, take the water pump and feed the long transformer cable which ends
with 2 pins down through the central white pipe until it can be pulled out through the bottom.
STAGE 3
Position the top section of the fountain over the pump ensuring that the LED light wire is connected
to the cable extending from the pump and the water tubing is connected to the pump outlet.
STAGE 4
Carefully pull the transformer wire through the base of the fountain. Push the cable with 2 pins into
the transformer and screw over the plastic collar.
STAGE 5
Fill the fountain with sufficient water to ensure that the pump is fully submerged.
STAGE 6
Connect the plug to your mains outlet.
HELPFULL TIP
Get a second person to hold the 'pebble' section of the fountain whilst pulling the wire through the
bottom of the pedestal.
The transformer should never be submerged or stood in water.
Please note the transformer will get hot while in use, this is normal.
PUMP FLOW: The pump flow
can be adjusted with the
regulator, this is found on the
inlet of the pump. We
recommend starting with the
flow regulator fully open and
then adjusting down if required.
www.kelkay.com
ELECTRICAL SAFETY: If outdoors the outlet must be
waterproof. We recommend the use of a residual current device
(GFI) Ground Fault Interrupter (available from all good D.I.Y.
stores) when connecting the fountain to the electric supply.