Lopolight 300-038 Installation Manual

P/N 601-322 Rev 1.00
Thank you for purchasing a Lopolight product. Our products are built to ensure a long
lifetime in the most extreme marine conditions.
Mounting: Mounting: Mounting: Mounting:
Go to www.lopolight.com or use the QR code
to get to the 'products' section where the
datasheet, that includes the dimensional
drawing, is found.
The alignment to vessel centerline is very important.
Horizontally mounted lights are opened/closed as illustrated.
Please ensure lock screw engages correctly.
Connecting power: Connecting power:
Connecting power: Connecting power:
Supply Voltage: Any DC voltage between 20 and 32 volts (24 Volt systems).
C C C C abled lights abled lights: : : :
abled lights abled lights
Recommended fuse or circuit breaker: Less than 2A (slow). Recommended fuse or circuit breaker:
Recommended fuse or circuit breaker: Recommended fuse or circuit breaker:
Grounding: The navigation light housing should not be connected to ground (Earth). Grounding:
Grounding: Grounding:
(We recommend that you connect the cable screen to ground (Earth)).
Cabling Cabl ing: : : : Avoid chafe and route it away from sources of heat and large inductive
Cabl Cabl ing ing
fields such as electric motors.
P/N 601-322 Rev 1.00 / 12 August 2020
Masthead lights: 300-036, 300-037, 300-038, 300-039, 300-136, 300-137, 300-138, 300-139
Installation guide Installation guide Installation guide Installation guide
Red wire: Positive (+)
(Double light: cables, same colour)
Light with green connector: Light with green connector:
Light with green Light with green connector: connector:
Single light:
Pin 1: Positive (+) Pin 2: Negative ( - ) (pin 3-5: not used)
Double light:
Primary light: Pin 1: Positive (+) Pin 2: Negative ( - )
Secondary light: Pin 4: Positive (+) Pin 5: Negative ( - ) (pin 3
not used)
Black wire: Negative ( - ). Black
Black Black