Download Print this page

Sealey ATL07 Instructions

Aluminium telescopic ladders

Advertisement

Quick Links

Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS.
USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE
DAMAGE OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY INSTRUCTIONS
1.1.
GENERAL SAFETY.
DANGER! Take care when using and moving extended ladders in the vicinity of power cables - risk of potentially fatal electric
shock.
WARNING! Ensure Health and Safety, local authority, and general workshop practice regulations are adhered to when using this
equipment.
Familiarise yourself with the application and limitations of the ladder, as well as the potential hazards.
Maintain the ladder in good condition.
Keep the work area clean, uncluttered and ensure there is adequate lighting.
WARNING! Use ladder on level and solid ground and either have an assistant stand on the lowest rung or otherwise anchor the base
of the ladder to prevent slipping. Ensure that the surface the ladder is standing on is able to support both the weight of the ladder and
yourself.
WARNING! DO NOT use the ladder on sloping ground. When viewed from the front, the top of the ladder section(s) must always
be directly above the base.
DO NOT use the ladder on a wet floor surface, or a floor surface contaminated with oil or similar substances.
For stability, place the ladder so that it is at an angle of 65° to 75° to the ground, the foot of the ladder should be 1 metre from the wall for
every 3 metres of elevation.
Where possible, attach top of ladder to a fixture to prevent slipping.
WARNING! Never over-reach when on the ladder, keep close to the centre line of the ladder.
Keep children and unauthorised persons away from the working area and DO NOT allow children to climb the ladder.
DO NOT use the ladder for any purpose other than that for which it is designed.
DO NOT use the ladder if it is damaged or any parts are missing, as this may cause failure and/or personal injury.
DO NOT exceed the rated weight capacity of the ladder.
DO NOT climb higher than the second rung from the top of the ladder.
DO NOT use the ladder when you are tired or under the influence of alcohol, drugs or intoxicating medication.
Take care when lowering the ladder, ensuring that hands are kept clear of the rungs.
Wear slip resistant footwear, and ensure that the footwears' soles and the rungs of the ladder are free of oil or similar substances.
Hold on to the ladder at all times when climbing.
When not in use, ensure ladder is fully retracted and store in a safe, dry, childproof location.
2. INTRODUCTION
2.1
Introduction
Extends and locks rung by rung allowing use at multiple heights. Fold down finger guards ensure that hands cannot get trapped while
ladder is lowered. Closed heights range of 795mm (ATL07), 875mm (ATL09), 880mm (ATL11) and 1010mm (ATL13) for easy storage
and transportation make this ideal for surveyors, tradesmen and domestic use. Lightweight, corrosion resistant aluminium frame. Rubber
feet offer increased stability while in use. Manufactured to BS EN 131 with 150kg capacity.
3. SPECIFICATION
Model No:
Treads:
Minimum Height:
Maximum Extension:
Maximum Capacity:
Weight:
4. INSTRUCTIONS FOR USE
4.1
Locking Mechanism (Fig.1)
4.1.1 The ladder locks every section with two steel locking levers that spring into place when the
ladder is extended. When the section is securely locked into place, the levers will be
positioned towards the outer edges of the rung.
4.1.2 When retracting the ladder slide both the levers towards the centre to release the section
(refer to Section 4.4).
WARNING! Ensure that all locks are fully engaged into their locking positions before
using the ladder.
ATL07
ATL09
7
9
795mm
875mm
2090mm
2690mm
150kg
150kg
5.5kg
8kg
INSTRUCTIONS FOR:
ALUMINIUM TELESCOPIC LADDERS
MODEL No's. ATL07, ATL09, ATL11, ATL13
ATL11
11
880mm
3215mm
150kg
10.5kg
ATL07, ATL09, ATL11, ATL13
ATL13
13
1015mm
3870mm
150kg
13kg
Fig.1
Issue: 1 - 08/12/11

Advertisement

loading

Summary of Contents for Sealey ATL07

  • Page 1 ALUMINIUM TELESCOPIC LADDERS MODEL No's. ATL07, ATL09, ATL11, ATL13 Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions and properly maintained, give you years of trouble free performance.
  • Page 2 WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim. INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode. Sole UK Distributor, Sealey Group, www.sealey.co.uk...

This manual is also suitable for:

Atl09Atl11Atl13