Panasonic TC-P55VT60 Technical Troubleshooting Manual page 61

Troubleshooting 8 Blinks Failure (All VT60 and ZT60 Models)
Applies to
Models
TC-P55VT60
TC-P60VT60
TC-P65VT60
Check all the cables between the SS board and the panel. Make sure they are
TC-P60ZT60
properly seated in the connectors. Unplug the TV and disconnect SS33 on the SS
board. Plug in the TV.
TC-P65ZT60
after the TV is plugged in as expected, then press the power switch.
8 blinks
Replace the
A board
Unplug the TV. Check for continuity between pins 1 and 2 of connectors SS62 ~SS67on the SS board. Do not plug in the
Check connections between
the SS board and the panel. If
ok, then replace the panel.
Note: Check for loose
screws on the SS board.
Start Here
Note: If the power LED does not turn on automatically
Does the TV
No
turn on and
stay on with
no picture?
TV.
Is continuity
No
OK in all the
connectors?
Blink List of boards likely to cause this symptom.
Code
No.1 No.2
8 Blinks SS A
Yes
Perform this test
while the TV is
Yes
No.3 No.4
Panel
SS62-67
unplugged.
Replace the SS
board
Slide 61 Slide 61