Page 2
Install the WDS onto the drum hatch. Drill a 17/32" hole in the drum hatch. Use the step drill bit to get close and then the 17/32” bit to complete the hole. VM0214 Drill Bit, Step 1/4"-3/4" VM0279 Drill Bit, Cobalt 17/32"...
Page 3
Use two strips of duct tape to hold the sensor in place until the adhesive sets. VM0481 Duct Tape, 2" Wide Gray 50 YD Roll Allow the adhesive to set overnight before putting the truck into service. 1.3 C ONNECTIONS The WDS is a wireless device and has no connections.