Watco Innovator CableFlex 928 Instructions For Installing

Instructions for Installing Watco Innovator
Models: Watco CableFlex™: 928, 938, 948 – Watco Cable: 970, 980, 990 – Half Kits: 971, 981, 991
13
14
14
15
19
16
3
Step 5: Screw on the overflow elbow (OE) nut (Item 3)
from inside of the tub
ONLY
compressed against the back of the tub.
minimum of 1½ turns when installing the nut.
not enough threads sticking through the tub to get the nut
installed, remove the thick gasket (Item 12) and replace it
with the thin gasket (Item 11).
Figure 2
21
22
26
Step 7: Screw the strainer test plug (Item 26) into the strainer
body Item 21) and test the system
Figure 5
© 2011 Watco Manufacturing Company
WATCO MANUFACTURING COMPANY
Step 1: Cut the 1½" Schedule 40 (or Flexible PVC) overflow pipe and drain pipe (Items 14 and 16) to the
desired lengths to fit the tub.
Step 2: Using standard solvent cement procedures, assemble the bath drain pipe and fittings (Items 13-16, and 19).
DO NOT LET SOLVENT CEMENT FLOW INSIDE THE OVERFLOW OR DRAIN ELBOWS PAST THE
SOCKET! Any excess glue will prevent the bath waste from operating.
16
Step 3: Place the thick foam gasket (Item 12) onto the overflow elbow (Item 13).
The testing membrane will still be attached.
thin gasket (Item 11).
Step 4: Insert the overflow elbow and
foam gasket assembly through the tub
overflow hole from the back of the tub
(Figure 1).
(Figure 2).
until the nut is snug and the gasket is only slightly
25
24
21
22
20
19
If the bath waste will not be pressure tested, skip to step 8.
(Figure
Step 8: After the pressure testing is complete, remove
the test plug (Item 26). Cut away and discard the orange
test membrane from the overflow elbow
caution not to damage internal parts on the inside of the
overflow elbow.
Thick-walled tubs will require the
Figure 1
HAND TIGHTEN
You must get a
If there are
Step 6: Secure the drain elbow (Item 19) and drain
flange gasket (Item 20) under the tub by screwing
in the strainer body (Item 21) through the tub
drain hole from inside the tub
If desired, a putty or sealant may be used between
the flange of the strainer body and the tub.
CAUTION: Do not use linseed oil based putty
products. Use only thread compounds specifically
intended either for ABS or PVC assembly.
5).
Page 1
Cable Bath Wastes
®
Figure 3
(Figures 3 and 4).
Figure 4
(Figure 6). Use
Figure 6
13
12
11
Continued next page.
970INST Rev. 4/11