ETen G500+ User Manual page 24

1. To remove the back cover, press the fixing lock button on the rear side of
the Pocket PC. Unlock the main battery lock and remove the main battery.
(If you are opening this product for the first time, the main battery and the
Pocket PC are packed separately inside the product package.)
2. Install the main battery properly and lock the battery securely. Slide the
back cover into the groove until you hear a click to indicate that the back
cover lock is locked properly.
3. Connect the AC adapter plug to any household power outlet, and then
connect the round plug from the AC adapter to the power connector. The
Pocket PC starts to charge automatically.
4. Cold Boot: Press and hold the "Power Button" with one hand, and use the
stylus tip to press the "Reset Button" with the other hand. Release the
"Power Button" and the "Reset Button" at the same time. Wait for the
Pocket PC to restart and follow the instructions on the screen to complete
screen alignment.
5. It will take about 8 hours to fully charge the battery after the first time you
open the package. Subsequent charging will only take about 3 hours. After
charging, you can disconnect the AC adapter and carry the Pocket PC
around portably. To maintain smooth operation, charge the power
regularly.
6. View the battery icon
usage condition.
7. The LED indicator on the upper right of Pocket PC will display the
charging and function usage status.
Charging
Red LED lights up
Phone is on
Green LED flashes
2-6
on the upper right corner to check the power
Fully charged
Red LED goes off
Caution or Warning
Orange LED flashes quickly
Insufficient power
Red LED flashes