Advertisement
Quick Links
Panduit Corp. 2019
INTRODUCTION
The TMSTEH-TOOL installs stud mounts with the aid of a power drill reducing the risk of repetitive injury.
Mounts grip onto the tool due to the interference fit of the drafted side walls allowing the installation to be a one
hand operation when needed. Follow instructions below to insure optimum performance from the TMSTEHS
series stud mounts.
WARNING: SAFETY GLASSES MUST BE WORN AT ALL TIMES WHILE
FIG 01
3
1
4
TMSTEH-TOOL
TMSTEH-TOOL OPERATION INSTRUCTIONS
FOR USE WITH: TMSTEH SERIES STUD MOUNTS
USING THIS TOOL.
Page: 1 of 2
1. Insert TMSTEH-TOOL into 3/8" drill
chuck as deep as possible and tighten
chuck onto tool.
2. Set drill to "screw" or "torque" setting.
3. Set the torque control to the lowest
setting. Generally, this would be a
setting of 1.
4. Press TMSTEHS* mount on tool.
5. Center mount opening on stud and use
drill to thread the mount on until torque
setting has been reached.
PA29513A01
Rev. 00 8-2019
Original Instructions
Advertisement
Summary of Contents for Panduit TMSTEH-TOOL
- Page 1 INTRODUCTION The TMSTEH-TOOL installs stud mounts with the aid of a power drill reducing the risk of repetitive injury. Mounts grip onto the tool due to the interference fit of the drafted side walls allowing the installation to be a one hand operation when needed.
- Page 2 OPERATION INSTRUCTIONS TMSTEH-TOOL © Panduit Corp. 2019 6 & 7 6. If mount is not fully seated on threaded stud, increase torque setting on drill by 1 and attempt install again. 7. Repeat step 6 until mount is fully seated on threaded stud.