Universal Furniture 311-755 Instruction Sheet

311/316/318-755
Thank you for purchasing this quality product. Be sure to check all packing material carefully for small
parts that may have come loose inside the carton during shipment.
Caution: (1) These parts are cumbersome and heavy. This product can best be assembled with the
assistance of one or more persons in order to prevent personal injury and to insure parts are not damaged
during the assembly process. If dirty, clean finished parts with mild dishwashing liquid and water solution
applied on damp cloth. Cloth should not be excessively wet. Polish finish with soft cloth and an industry
recognized furniture polish.
(2) To prevent damage to your floor or carpet, please check the bottom of each piece of furniture for
stain residue and rough surfaces and also check for staples or nails left after removing the packaging material.
The manufacturer will not be held responsible if preventative steps are not taken prior to installation.
(3) Unpack and dispose of all packing material but be careful not to throw away any assembly parts or
hardware. Read the instruction sheet and parts list carefully. Remove all staples and screws used for
packaging carefully using pliers and or screwdrivers to prevent injury and scratching or damaging flooring.
(4) During normal use everyday, screws, bolts, nuts and wooden plugs may loosen up. They should be
periodically inspected and re-tightened to prevent damage to the furniture and (or) personal property or cause
injury. Always check to be sure all hardware on this list and the above mentioned components is attached to
the furniture properly and kept tightened at all times.
PARTS LIST:
# Description
A Table Top
C Connecting Rail
E Decorative Pad
Assembly Procedure
Step 1: Unpack, inspect, and read assembly instruction carefully. Lay out the parts and hardware.
Make sure the quantity of each is correct.
Step 2: Detach the mounting plate (B) from bottom of table top (A) with wrench (7). Keep the bolts,
spring washers and flat washers for step 4.
Step 3: Insert wood dowels (9) into the predrilled holes in the side posts (D), and then attach
connecting rail (C) to side posts (D) from outside of side posts (D) with allen head bolts (4),
spring washers (5) and flat washers (6) using allen wrench (8). Fill the holes on the outside
of side posts (D) with decorative pad (E) on both side. Then attach mounting plates (B) to top
of side posts (D) with nuts (1), spring washers (2) and flat washers (3) using wrench (4).
Step 4: Turn the base over, and attach the mounting plate (B) to the table top (A) with the bolts, lock
washers and flat washers from step 2.
Step 6: Turn the table upright.
Note: If handled improperly, the act of installing and removing table leaf may damage the table.
Please use caution and delicate handling when installing and removing table leaf to prevent
damaging the table top surface and edges. It is best two persons are involved when installing or
removing table leaf.
Assembly is now complete.
INSTRUCTION SHEET
Qty. #
1pc B
1pc D
2pcs F
: (Please follow the sketches below.)
Page 1 of 2
Flat Iron Table
Description
Mounting Plate
Side Post
Hardware pack
Qty.
2pcs
2pcs
1bag