Universal Furniture 311 807 Instruction Sheet

311/316/318 807 & 810
Thank you for purchasing this quality product. Be sure to check all packing material carefully for small
parts that may have come loose inside the carton during shipment.
Caution: (1) These parts are cumbersome and heavy. This product can best be assembled with the
assistance of one or more persons in order to prevent personal injury and to insure parts are not damaged
during the assembly process. If dirty, clean finished parts with mild dishwashing liquid and water solution
applied on damp cloth. Cloth should not be excessively wet. Polish finish with soft cloth and an industry
recognized furniture polish.
(2) To prevent damage to your floor or carpet, please check the bottom of each piece of furniture for
stain residue and rough surfaces and also check for staples or nails left after removing the packaging material.
The manufacturer will not be held responsible if preventative steps are not taken prior to installation.
(3) Unpack and dispose of all packing material but be careful not to throw away any assembly parts or
hardware. Read the instruction sheet and parts list carefully. Remove all staples and screws used for
packaging carefully using pliers and or screwdrivers to prevent injury and scratching or damaging flooring.
(4) During normal use everyday, screws, bolts, nuts and wooden plugs may loosen up. They should be
periodically inspected and re-tightened to prevent damage to the furniture and (or) personal property or cause
injury. Always check to be sure all hardware on this list and the above mentioned components is attached to
the furniture properly and kept tightened at all times.
PARTS LIST:
# Description
A Table Top
C Rail
Assembly Procedure: (Please follow the sketches below.)
Step 1: Put the parts on a flat, soft surface such as a carpet or cloth to prevent scratching the finish.
Attach the side frames (B) to the rails (C) using bolts (1). Securely tighten by screwdriver
(not provided), but do not over tighten the bolts.
Step 2: Attach the assembled base to the table top (A) using flat washers (2), spring washers (3)
and nuts (4). Tighten by hand at first, securely tighten by wrench (5), but do not over tighten.
Step 3: Carefully turn the assembled table to an upright position. Your furniture comes with
adjustable levelers and can be adjusted as shown in diagram. The adjustable levelers can
be turned clockwise and counter clockwise to level the unit as required.
Assembly is now complete.
INSTRUCTION SHEET
Qty. # Description
1pc B Side Frame
2pcs D Hardware Pack
Page 1 of 2
Accent Tables
Qty.
2pcs
1bag