HPM HL12FS-BP Instruction Manual

1 Range
A B
Part No
(mm) (mm)
HL12FS-BP 425 265
HEE18FS-BP 367 384
HL24FS-BP 550 265
HL36FS-BP 675 265
HL48FS-BP 800 265
2 Standards
Reference : AS3000:2007 wiring rules requirement (Clause : 3.9.4.4 (b).
3
Installation
Step 1:
Position the plate so that
overhang is on the side of the
incoming cable. Mark drilling
holes to fix the plate on back of
the enclosure with the help of
pre-drilled holes on back plate
(5 holes to mark : 4 corners +
earth).
Cat. HL12FS-BP, HEE18FS-BP, HL24FS-BP, HL36FS-BP, HL48FS-BP
Thickness to suit
(mm) enclosure
0.9 HL12F
0.9 HEE18F
A
0.9 HL24F
0.9 HL36F
0.9 HL48F
Step 2:
Drill with 4mm bit on back of the
enclosure.
Step 3:
Fix back plate to enclosure using
bolts, washers & nuts provided.
Make sure the overhang is
covering unprotected cables (top
or bottom).
Earthed Metal Back Plate
to suit HL/HEE Flush Load Centres
B
Metal plate back
Instruction Manual
Flush enclosure
Step 4:
Fix 4mm² earth strap to the earth
bar and stud (overhang portion on
the side of the earth terminal)