Cirrus CC34IQ63SB Quick Start Manual

OPERATION
Controls (Fig.2)
The hood is operated using the (5) push buttons located on the hood and the remote con-
trol.
LED colors are displyed on hood control only.
(P1) Delay- Off Switch
• Your hood includes a 10 minute blower delay off switch. Press this switch once to activate
the timer and the LED Ring (L1) fl ashes blue. The blower will continue to operate for
10 minutes. After 10 minutes, the blower turns off automatically.
• To cancel the 10-minute delay, press the delay switch once again.
(P2) Filter Alarm Switch
• After 30 hours of blower operation, the fi lter alarm is activated and the LED ring (L1) turns
red/fl ashes. It indicates that the grease fi lters need to be cleaned.
• After cleaning the grease fi lters, reset the hour counter by pressing the Filter Alarm/Timer
Reset button (P2) during display of the alarm.
(P3) Blower Speed Decrease and Off Switch
• Press to decrease blower speed, high to low. The LED ring (L1) fl ashes blue at a speed
proportionate to the blower setting (i.e.: four fl ashes is high speed, one fl ash is low
speed, etc.)
• Continue pressing this switch to turn the blower off.
(P4) Blower Speed Increase and On Switch
• Press this switch to turn the blower on to low speed.
• Press again to increase blower speed, low to high. The LED ring (L1) fl ashes blue at a
speed proportionate to the blower setting (i.e.: four fl ashes is high speed, one fl ash is low
speed, etc.)
(P5) Light Switch
Lights off/low/medium/high.
P1: Activate/deactivate delay-off (10 minute)
P2: Filter change indication timer reset
P3: Decreases fan motor speed until turned off (4>3>2>1>OFF)
P4: Turns fan motor on and increased speed (ON>1>2>3>4)
P5: Lights off/low/medium/high
L1: LED Indicator Ring Signalling crown:
- Hood in standby: lights up green. 30 seconds after
the last key has been pressed the crown turns off
- Motor on: L1 lights up blue fl ashing. The fl ashing
frequency is proportional to the speed setting.
L1
- 10' TIMER function : L1 lights up and fl ashes blue.
LED
- Filter alarm active: L1 lights up red
RING
- 6 -
FIG. 2