PacLights FHZL Series Installation Manual

INSTALLATION GUIDE
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
PacLights fi xtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is required for safety.
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR
WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNINGS:
• MIN 90°C SUPPLY CONDUCTOR. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE
INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE
HAZARDS INVOLVED.
• Make certain power is OFF before installing or maintaining fi xture. No user serviceable parts inside.
• To prevent wiring damage or abrasion, do not expose wiring to edges of sharp objects.
CAUTION:
• For proper weatherproof function all gaskets must be seated properly and all screws inserted and tightened fi rmly. Apply weatherproof silicone
sealant around the edge of the Back Box and/or Junction Box. This is especially important with an uneven wall surface. Silicone all plugs and
unused conduit entries.
FHZL THREADED PIPE MOUNTING & CONDUIT INSTALLATION
The FHZL Threaded Pipe Mount is installed from the top and the Conduit from the side of the fi xture with the wiring. The FHZL Series Wiring requires
the Driver Box Cover to be removed. Remove the 3/4" NPT Nut (side or top of fi xture), the Screw Cap Covers and loosen the Screws (Fig. 1). Open the
Driver Box Cover and the Lanyard will hold the Cover to prevent it from falling off . Pull the Wiring (Aluminum or Copper conductors) through one of the
theaded holes and connect to the Terminal Block (Fig. 2 or 3). Re-install the Driver Box Cover, Pipe at the top or Conduit at the side (Both Not Included)
in place of the 3/4" NPT Nut (Use silicone gel around the threads for water tight seal), Screws, and Screw Caps in the reverse order. For top installation,
tighten the fi xing Screw to the Pipe (Fig. 2).
SCREW
CAPS
DRIVER BOX
COVER
SCREWS
FIG. 1
WIRING DIAGRAM
Connect the ACL and the ACN from the FHZL Fixture to the conduit with the AC power Supply Cable. Follow the Wiring Diagram provided.
AC POWER SUPPLY
PL_INST_FHZL_v0
FHZL Series LED Hazardous Location Lighting
FHZL 040
3/4" NPT
NUTS
SCREW
LANYARD
FIG. 2
HOT [BLACK]
NEUTRAL [WHITE]
GROUND [GREEN]
Need help? (800) 988 -6386 Email: CS@PacLights.com Website: www.PacLights.com
Instructions and specifi cations are subject to change at any time without notice. Copyright© 2021 PacLights All Rights Reserved
IMPORTANT
PIPE
WIRING
TERMINAL
BLOCK
FHZL DRIVER
FHZL 080/120
TERMINAL
BLOCK
LANYARD
FIG. 3
DIM
WIRING
CONDUIT
Page 1 of 5