GALLUNOPTIMAL GOSprint65 Operating Instructions

GALLUNOPTIMAL
THANK YOU FOR PURCHASING A GALLUNOPTIMAL SOLDERING IRON. Please read the operating instructions
before use and keep them in a safe place easily accessible to all users.
The soldering iron needs to be tested before it leaves the factory, so the soldering tip may cover a small
amount of tin, and the casing will be slightly yellowing, which is a normal phenomenon.
Disregarding the following instructions can lead to serious injury or death of the user.
When the unit is switched on, the soldering tip automatically heats up to the last set temperature.
There is a risk of burns on the surfaces!
The device is designed for soldering soft solder with different temperatures. Any other use is not permitted.
Do not touch the metal parts on the tools during operation and immediately after switching off, CAUTION! Danger
of burns!
Do not use the device near flammable materials and components.
Use a heat-resistant work surface and keep your workplace clean.
Solders, fluxes and heated materials can develop harmful properties and should be extracted in a controlled
manner. Do not inhale these toxic vapours or gases and ensure adequate ventilation.
The device may only be used for operation in dry indoor areas. Protect the device from liquids and moisture, even
by possibly wet hands. Otherwise, short circuits and electric shocks could be caused.
Inform other people in the work area that the temperature can be very high during operation. Switch off the unit
as soon as the work is finished to avoid danger.
Do not leave the appliance unattended while it is switched on.
After switching off, wait until the heated parts have reached room temperature if you want to touch parts or
change parts.
Features
Specification
Turn it on:
Plug the power cable into the
socket and press Power at the soldering iron.
With the +/- keys 9 different temperature setting
ranges can be selected.
press Menü
long
Temperature unit
Soldering iron with temperature control / Auto-Standby after 10 minutes / Sleep mode
after 20 minutes / Ceramic PTC heating element (3-pole, grounded) / Temperature
adjustable via buttons on soldering iron / Ergonomic handle
Valtage Power
110/240VAC 65W
change Temperatur
Standby
short
Soldering Iron Sprint65
WARNUNG
Temp. Stability
range
80-480°C +/-2°C
Stainless steal
outer casing
Soldering tip
Temperature compensation
short
Working mode
short
Heater Heating
indication
PTC LED
Minus button
Add button
Shell
250°C/482°F, 300°C/572°F, 325°C/617°F,
350°C/662°F, 375°C/707°F, 400°C/752°F,
425°C/797°F, 450°C/842°F, 480°C/896°F
Temp. Display
unit
°C/°F LCD
Power/Menü button
3corded
Display
power cabel
short