Xcortech X3300W Quick Start Manual

CH-1. X3300W units

X3300CC : Command center control system.
A. Available in Black and Tan color.
B. Uses 2 x AA batteries.
X3300MF : Muzzle Flamer /Tracer Unit.
A. Available in Black Color
B. Uses 4 x AAA, Alkaline or Eneloop batteries
X3300SCU (optional): Shot Control Unit (SCU)
Controls burst mode through the by command
center. Module.
** The X3300CC and X3300MF has paired in factory.
That can't mix CC and MF with else.
X3300MF operation
● Power : ON/OFF
● Power indicator : Green light is running, Red light
indicates low battery
Unit will Auto power off if not used for 10 mins
● Inner barrel length to insert Max 40mm
● X3300W install :
1. Install X3300MF on the reverse 14mm thread of AEG barrel ( Fig. 1)
2. Install X3300CC on your AEG's tactical rail ( Fig. 1)
3. Connect the X3300SCU to the AEG's Battery ( Fig. 2) - (optional).
4. Turn on the X3300MF and X3300CC power
5. Configure the X3300CC settings
6. X3300CC and X3300SCU need to be linked together after binding/pairing
7. X3300SCU controls burst mode with low-voltage protection (optional)
● X3300CC and X3300SCU binding /pairing:
1. Set the X3300CC "Mode Selector" to "ST", rotate the "Data Wheel" to ScU
then push the "Data Wheel", select to "MEM" and push the "Data Wheel"
2. In "MEM", select Memory 1 ~ 8
Ex: Select "1" then "Data Wheel"
3. Rotate "Data Wheel" to select, "bind" will display "[ 1 ]", in the "[
4. Push X3300SCU switch on the PCB
5. X3300CC displays a "[ 1 ]" that will flash repeatedly, indicating settings are
complete
6. The X3300CC has 8 memory channels for binding/pairing
※ Reference "X3300W ScU shot control unit in Ch5

CH-3. X3300W Kits operation

X3300CC operation:
● Mode Selector:
1. ROF (roF) : Displays rate of fire (Rounds per-minute)
2. SPD (SPd) : Displays BB Velocity
3. DN (dn) : Display count down
4. UP (UP) : Display count up
5. 0 (oFF) : Power off
6. ST (SEt) : Set Command center
● Data Wheel (pushable): Rotate the "Data Wheel" to set the Data
1. In ROF/SPD/DN/UP mode :
A. Rotate "Data Wheel" : To adjust screen brightness
B. Push and hold 2sec : To reset UP and preset DN count.
C. Quickly push "Data Wheel" 3 times :
To select Burst/Auto firing mode (Display shows brSt / AUto
2. In ST mode :
A. Rotate "Data Wheel" : Select parameter or set it.
B. Push "Data Wheel" : To confirm the parameter.
● Display 4 Digits-Display
X3300SCU operation
● Binding/pairing SW

CH-2. Installation

]" flashing