How to Install Custom Vertical Valance
VALANCE STYLES
The following illustrations show installed examples of some common valance styles. Refer to the installation that matches your valance.
Designline
Valance
™
BEFORE YOU BEGIN:
Please refer to the illustrated examples to determine which clips and instructions you will need.
Twist-lock Valance Clips
INSTALLING VALANCE CLIPS
STEP A
Install the valance clips — DesignLine
(outside-mount)
• NOTE: Headrail mounting shown in installed position to show
typical mounting bracket locations.
• Position one clip at each end of the headrail next to the headrail
mounting bracket locations. Make sure that the clips do not
interfere with the mounting brackets.
• Lower the clip into the top channel of the headrail at 45° angle
to the headrail so the locking tabs fit into the channel.
STEP B
Install the valance clips — DesignLine
• NOTE: Valance clips must be installed prior to headrail installation.
• Position one clip at each end of the headrail, next to the headrail mounting bracket
locations. Make sure that the clips do not interfere with the mounting brackets.
• Lower the clip into the top channel of the headrail at a 45° angle to the headrail so
the locking tabs fit into the channel.
• Rotate the clip in the channel so that it locks into place.
Traditional Valance
, Traditional and Transitional
™
, Traditional and Transitional (inside-mount)
™
Transitional Valance
Visions
Valance Clips
™
• Rotate the clip in the channel so that it locks into place.
• Space remaining clips evenly between the ends, not more than
30" apart.
How to Install Custom Vertical Valance
Visions
Faux Wood Valance
™
1