Maxitrol GF40-1-44 Installation And Service

Gas Filters
and for other applications such as air
½", ¾", 1", 1¼", 1½", 2" NPT or ISO 7-1
Maxitrol filters are suitable for application in natural, manu-
factured, mixed gases, liquefied petroleum gases and LP gas-air
mixture piping systems.
Changes to the NFPA (National Fire Protection Association) 86
Standard require a gas filter or strainer be installed in the fuel gas
supply line, on new oven and furnace installations.
The filters are tested according to DIN 3386 and have
DIN/DVGW approval. The filters are approved according to Eu-
ropean Gas Appliance Directive 90/396/EG, Pressure Equipment
Directive 97/23/E, the Russian GOST, and the Hungarian MBVTI
requirements. Filters with NPT threads are not covered by Euro-
pean certification.
Unique filter matting effectively separates dust. The matting has
an extremely high capacity for accumulated dust due to its wide
filtering surface and depth effect. The material will not allow par-
ticulate infiltration over 0.05mm (50 microns). The inserts are quick
and easy to replace.
The filter housing's compact size allows for easy
original equipment installation or retrofitting.
Specifications
• Housing's are made of durable cast aluminum
• Filter matting consists of polypropylene impregnated fleece
• Rp or Rc thread (parallel or taper) dimensions according to
ISO 7-1. NPT thread according to ANSI.
• Maximum operating inlet pressure: 15 psi (1 bar)
• Ambient temperature limit: 175° F (80° C)
GF40 models
* Dimensions (inches/millimeters) are maximums and are to be used only as an aid in designing clearance for the filter.
Actual production dimensions may vary somewhat from those shown.
Pipe Size
1/2"
3/4"
1"
1-1/4"
1-1/2"
2"
GF60 models
1
NPT Model ISO 7-1 Model
GF40-1-44 GF40M-1-44
GF60-1-66 GF60M-1-66
GF60-1-88 GF60M-1-88
GF80-1-1010 GF80M-1-1010
GF80-1-1212 GF80M-1-1212
GF80-1-1616 GF80M-1-1616
GF80 models