Sealey RJAS2500.V3 Quick Start Manual

thank you for purchasing a Sealey product. manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear safety
instructions footwear
1. SAfety
ensure the jack is in sound condition and good working order. Take action for immediate repair or
9
replacement of damaged parts. Use genuine parts only. The use of improper parts may be dangerous and
will invalidate the warranty.
locate the jack in a suitable, well lit working area.
9
Keep working area clean and tidy and free from unrelated materials. Use jack on level and solid ground,
9
preferably concrete.
Avoid tarmacadam as jack may sink in.
9
Chock wheels of vehicle.
9
ensure the vehicle handbrake is engaged, engine is switched off and transmission is in gear (or "PARK" if
9
automatic).
ensure minimum distance of 0.5m between vehicle and static objects such as doors, walls, etc., to allow
9
for vehicle tilting.
ensure all non-essential persons keep a safe distance whilst the jack is in use.
9
ensure there are no passengers in the vehicle.
9
Place jack under only those lifting points recommended by vehicle manufacturer (see vehicle handbook).
9
Check that the lifting point is stable and centred on the jack saddle.
9
ensure the jack wheels are free to move and that there are no obstructions.
9
▲ DAnGer: Use the jack for lifting only, noT for supporting the lifted load.
ensure there are no persons or obstructions beneath the vehicle before lowering.
9
Use suitable axle stands under the vehicle before proceeding with any task.
9
Use a qualified person to lubricate and maintain the jack.
9
Do not operate the jack if damaged.
8
Do not allow untrained persons to operate the jack.
8
Do not exceed the rated capacity of the jack.
8
Do not allow the vehicle to move during lifting or lowering, or use the jack to move the vehicle.
8
Do not jack vehicle if there is a risk of spillage of fuel, battery acid, or other dangerous substances.
8
Do not work under the vehicle until appropriately rated axle stands have been correctly positioned.
8
Do not use the jack for purposes other than that for which it is intended.
8
Use hydraulic jack oil only. (Sealey Part no: HJo500MlS or HJo5lS)
9
Do not adjust the safety overload valve.
8
When not in use store jack, fully lowered, in a safe, dry, childproof area.
9
2. introDuction
Made primarily for the motor racing enthusiast, this jack weighs in at just over 25kg. Mix of steel and aluminium not only makes this jack
lightweight but incredibly strong. large saddle with jacking pad. Rocket lift with twin piston design enables saddle to be brought up to jacking
point with minimal pumps. Lifting bars are fitted either side of the anodised aluminium chassis enabling fast, lightweight pick-up.
3. SpecificAtion
model no: ....................................................... rJAS2500.V3
Capacity: .................................................................. 2.5tonne
Consumable Parts: ...........................Rubber Jack Pad - JP11
length: ....................................................................... 670mm
Maximum Chassis Height: .......................................... 142mm
Maximum Saddle Height: ........................................... 470mm
Minimum Saddle Height: .............................................. 95mm
© Jack Sealey limited
2.5tonne Aluminium/Steel trolley
JAck with rocket lift
rJAS2500.V3
Model no:
Original Language Version RJAS2500.V3 Issue 1 28/06/19