Advertisement
Quick Links
INSTRUCTION MANUAL
GB
GENERAL SAFETY INSTRUCTIONS
ATTENTION!
• The assembly must be carried out by a qualified fitter! It is
recommended that two people carry out the assembly.
• The ceiling rail system may only be attached to ceilings with an
appropriate load-bearing capacity!
• The structure of the ceiling must be suitably solid and suitable for
the subsequent total weight (including attached pantographs and
accessories). Never mount the ceiling rail system on a wooden ceiling
or an unstable or suspended ceiling!
• Always ensure that the mounting screws are properly anchored!
Note: Information on the weight of the ceiling rail system can be
found in the chapter "Technical data". The weight specifications for
other possible add-on parts can be found in the operating instructions
supplied with these parts.
DANGER FROM FALLING OR DROOPING PARTS!
• Make sure that the ceiling rail system is securely and stably mounted
before attaching other device accessories* to it.
• Secure all devices/accessories* mounted on the pantographs using
safety wire rope.
Fig. 1
PARTS OVERVIEW
Single slide rails Double slide rails Ceiling brackets Double carriage roller Single carriage roller (with integrated spigot connection)
Pantograph Spigot adapter Rail stopper Safety wire rope Knob screw
SCOPE OF DELIVERY
2x single slide rails 2x double slide rails Ceiling bracket (4x) Double carriage roller (4x) Single carriage roller (4x) Pantographs (4x)
Spigot adapter(4x) Rail stopper (12x) Safety wire rope (4x)
ADDITIONALLY REQUIRED*
Phillips screwdriver, 8 pcs. mounting screws (type M6) and, if necessary, suitable dowels/ceiling anchors for mounting the ceiling brackets
*not included with the purchase
(Fig. 1)
(Fig. 2)
BR-CR1
Ceiling rail system
with pantographs
• Lay the voltage and connection cables in such a way that they cannot
be damaged by the trolleys or cause strangulation to persons!
• Only use accessories that meet the required specifications. Find
more information in the chapter "Technical data".
• The maximum total load capacity of the ceiling rail system must
not be exceeded. At the maximum total load capacity, both the total
system weight and the weights of the mounted accessories/devices*
must be taken into account. Find detailed information on weights
under "Technical data" as well as in the manual of the mounted
accessory.
DANGER OF CRUSHING!
• Do not touch the guide rails during assembly, cleaning, operation
and when changing the position or moving the current collectors!
• Do not insert fingers into the lifting mechanism of the pantograph!
Art. No. F000224
Fig. 2
Advertisement
Summary of Contents for Bresser BR-CR1
- Page 1 BR-CR1 Ceiling rail system with pantographs INSTRUCTION MANUAL Art. No. F000224 GENERAL SAFETY INSTRUCTIONS ATTENTION! • The assembly must be carried out by a qualified fitter! It is • Lay the voltage and connection cables in such a way that they cannot recommended that two people carry out the assembly.
- Page 2 MOUNTING (Fig. 2-5) Fig. 3 Fig. 4 Step 1: The ceiling brackets (3) are already fixed to the floor with a Step 2: Mount the two single slide rails (1) at a distance of about 2 m distance of min.
- Page 3 Wrap the safety wire rope around the lower part of the pantograph (6) and the bracket (X) of the mounted accessory/equipment* and hook the snap hook (Y) into the loop (Z). When its done, the device/ accessory* is additionally secured against falling. WARRANTY www.bresser.de/warranty_terms *not included with the purchase...
- Page 4 @BresserEurope © 2021 Bresser GmbH, 46414 Rhede, Germany. No part of this manual may be reproduced, transmitted, transcribed or translated into any language in any form without the written permission of Bresser GmbH. Errors and technical changes reserved. Manual_F000224_BR-CR-1_en_BRESSER_v032021a...