About the design The E series amplifiers are based on the latest Texas Instruments class D controllers. This amplifier topology is the foundation for some of the world’s most efficient amplifiers. We took the typical Class D design, improved on it and made it suitable for car audio in all vehicles with...
Power Requirements 10V – 16V Operating Voltage Range Tested Voltage 14.4V 4Ω sine 2Ω sine 1Ω sine Current required to clip to clip to clip E350.2 applicable E400.4 applicable E660.5 applicable E750.1 E1000.1...
Fuses The amplifiers are shipped with the following fuse sizes. Always replace with the same rating. We have already oversized them for maximum performance. If fuse blows amplifier has serious fault or shorted speaker wire, or wrong impedance speakers connected. Model Fuse arrangement E350.2...
Specifications E350.2 E400.4 Continuous Sine Power 4Ω 100 x 2 60 x 4 2Ω 175 x 2 100 x 4 1Ω ---------- ---------- Continuous Sine Bridged 4Ω 350 x 1 200 x 2 2Ω ---------- ---------- 1Ω ---------- ---------- Crossovers 12dB/octave LP/HP/OFF LP/HP/OFF Frequency Response...
Page 7
Specifications E660.5 E750.1 E1000.1 Continuous Sine Power 4Ω 55 x 4 + 300 x 1 400 x 1 190 x 1 2Ω 90 x 4 + 500 x 1 700 x 1 300 x 1 1Ω ---------- 750 x 1 1000 x 1 Continuous Sine Bridged 4Ω...
COD. Customer is responsible for shipping charges and insurance in sending the product to D’Amore Engineering. Shipping damage on returns is not covered under warranty. To obtain service worldwide please e-mail D’Amore Engineering Info@DAmoreEngineering.com D’Amore Engineering E Series Amplifiers Owner’s Manual Rev. 2 2020...