EasyPro TS150 Instructions

High quality pumps designed for years of
energy effi cient continuous duty operation
One Year
Warranty!
INSTRUCTIONS
SPECIFICATIONS
Automatic overload and thermal protection with self
reset nylon housing.
Light weight housings made of engineering composite
with glass fi ber reinforcement.
Wear resistant nylon impeller.
High precision mechanical shaft seals.
Pump Specifi cation Table
Discharge 1 / " • Elbow 1
1
4
Voltage 115v, 60 hz • Power Cord 20'
Solid Max.
Model Watts HP Size Amps Head
TS150 150 1/4 1" 2.8-3.2 18'
TS250 300 1/3 7 / " 4.2-4.6 30'
8
TS400 400 1/2 3 / " 5.0-5.5 33'
4
ELECTRICAL SAFETY
Use dedicated power outlet only.
Sharing the outlet with other equipment may cause over
heating and fi re.
Install in accordance with all applicable safety regula-
tions.
Installation to be performed by qualifi ed electrician.
Do not use without proper grounding or electrical shock
may occur.
A GFI (ground fault interrupter) must be used in
conjunction with this pump!
/ "
1
2
POWER CORD
Max.
Flow Weight
Do not use an extension cord.
1800 gph 10.5 lbs.
Never submerge connecting power cable plug in water.
3000 gph 11.5 lbs.
Do not tamper with power cord.
3400 gph 12.3 lbs.
Do not use adapter that is not grounded.
Make sure power cable does not become bent, twisted,
abraded or cut.
Do not allow power cable to come in contact with
heated surface.
Damaged cable may cause electric leakage, shock or
fi re.
INSTALLATION
Do not paint casing, over heating may occur.
Life only by handle, not by power cable.
Do not hang water pump in water.
Install on solid fl at base in upright position.
Install proper outlet adapter for pipe or hose.
Discharge end of pipe or hose must be above water
level.
Make sure that power cable plug and power outlet are
away from water or water discharge pipe/hose.