FIXTURE INSTALLATION I INSTALLATION DU LUMINAIRE
IMPORTANT
GENERAL INFORMATION
Read and follow all safety instructions to avoid electric shock and proper
•
installation.
Save these instructions for future reference.
•
It is recommended to consult your electrician for all high voltage wiring to
•
the LED Class 2 drivers and connecting all 24V low voltage LED tape light.
All 24V Pinnacle Series Tape Light products come equipped with 3M
•
Self-Adhesive doubled sided tape. It is designed to be installed on NON-
POROUS surfaces only.
Installation surface must be cleaned and dry prior to the tape light being
•
applied.
For porous surfaces, it is recommended to seal the porous surface to ensure
•
the 3M self-adhesive tape will have a strong adhesion to the surface.
Another method for porous surfaces is to use an aluminum foil tape
•
before installing the tape light.
MAINTENANCE & CARE I ENTRETIEN
1. Ensure that the power is disconnected prior to servicing.
Avant de procéder à l'entretien, coupez le courant.
2. To keep the finish of this product, wipe with soft cloth periodically.
Pour préserver le fini de ce produit, essuyez le luminaire périodique-
ment avec un linge doux.
3. Do not use harsh chemical solvents as it may discolour or damage
the finish or lens.
N'utilisez pas de solvants chimiques puisqu'ils peuvent décolorer
ou endommager le fini ou la lentille.
Read all instructions in order to ensure safety and proper installation.
Lisez toutes les instructions afin d'assurer une installation sécuritaire.
SÉRIE I SERIES
PINNACLE
24V TAPE LIGHT I RUBAN LUMINEUX 24 V
INFORMATIONS GÉNÉRALES
Lisez et suivez les instructions de sécurité pour une installation conforme
•
et pour éviter tout risque de choc électrique.
Conservez ces instructions pour référence ultérieure.
•
Il est recommandé de faire appel à un électricien pour tout branchement
•
haute tension aux transformateurs (drivers) DEL de classe 2 et pour toute
connexion des rubans lumineux DEL 24 V à basse tension.
Tous les rubans lumineux 24 V de la série Pinnacle sont pourvus de
•
ruban adhésif double face 3M. Ils sont conçus pour être installés sur des
surfaces NON POREUSES uniquement.
La surface d'installation doit être propre et sèche avant d'y appliquer le
•
ruban lumineux.
Pour une installation sur des surfaces poreuses, il est recommandé de
•
sceller ces dernières afin d'assurer l'adhérence du ruban adhésif 3M.
Une autre méthode d'installation sur des surfaces poreuses consiste à
•
utiliser un ruban d'aluminium avant l'installation du ruban lumineux.
BEFORE INSTALLATION I AVANT D'INSTALLER
1. Read these instructions carefully before attempting to install this
product.
Lisez attentivement toutes les instructions avant d'installer ce produit.
2. Disconnect electrical power before installing or servicing any part
of this fixture.
Coupez le courant avant l'installation ou l'entretien de ce produit.
www.ndrelectric.com
t. 1.514.695.8228 I 1.855.739.8228
f. 1.514.695.9009 I 1.855.812.9009
TL200, TL250
TL350, TL600