Advertisement
Quick Links
ASSEMBLY INSTRUCTIONS
1
I Outrigger to be suspended from two cleats "a & b"
(Minimum 3' (1M) apart / maximum 16' ( 5M) apart
and a third cleat "c" centered between "a & b".
a
2
I Mount boot using appropriate fasteners
near bulkhead. Consult your boat
manufacturer or local shipyard repair
facility for mounting advise on
permanent hull attachments.
Position boot by
referring to
fig. 2, 3, & 4.
TM
c
3'–16'
(1M – 5M)
BULKHEAD
•Stabilizer System (R10-702) and
•Outrigger (R10-707)
For boats up to 40,000 lbs. one Rock 'n Roll Boat
Stabilizer is recommended. For boats over 40,000 lbs.
or in situations where more stabilization is required
we recommend two stabilizers.
3
I Apply marine bedding
compound between
boot and hull (Sikaflex
b
231 or equivalent).
4
I Position boot as shown for optimal operation
of Stabilizer/Outrigger system.
2' to 3'
Rock 'n Roll
®
™
Materials required
Depth Control
Retrievel
Line
Contents of R10-707
United States Patent No. 5,263,434
Contents of R10-702
United States Patent No. 5,095,839
HULL
BOOT
35º - 45º
Fasteners (4)
Line
MARINE
BEDDING
6" to 12"
Advertisement
Summary of Contents for Magma Rock 'n Roll R10-702
- Page 1 ASSEMBLY INSTRUCTIONS Rock ‘n Roll ® ™ •Stabilizer System (R10-702) and •Outrigger (R10-707) For boats up to 40,000 lbs. one Rock 'n Roll Boat Stabilizer is recommended. For boats over 40,000 lbs. or in situations where more stabilization is required we recommend two stabilizers.
- Page 2 I Cleat off rigging lines at cleats “a & b” so that outrigger is centered between cleats “a & b”. Magma recommends that a bowline knot (refer to fig. 6) be used on all cleats. I Tying a Bowline Knot...
- Page 3 I CAUTION: I Insert retrieval line through the attachment hole by entering from Handle stabilizer with top. Tie a figure 8 knot below leaving a 4" (10cm) tail and tie an bridle ring to prevent possible injury from additional single knot on the end for security as shown. pinching action between the stops of the Cleat off other end of line to center cleat “c”.
- Page 4 I Rinse with fresh water before stowing. I Leave all lines pre-set, coil individually with rubber bands. I Stow in bag as shown. ® MAGMA PRODUCTS INC. 3940 PIXIE AVENUE, LAKEWOOD, CA 90712 • USA TEL: (562) 627-0500 www.MagmaProducts.com • e-mail: mail@MagmaProducts.com...