70" X 40" DINING TABLE
IMPORTANT: PLEASE READ COMPLETE INSTRUCTION SHEET PRIOR TO ASSEMBLY!
Identify all parts packed in carton against the parts list. Remove all protective
materials, place parts on a nonabrasive surface to avoid scratching. If any parts
are missing or damaged, DO NOT attempt to assemble. Please contact our
customer service center (Monday-Friday 9:00 a.m.-5:00 p.m.CST) at
1-877-527-0313 or visit our website at www.homedepot.com.
Step 1
With the help of another person, turn the table top (A) upside down on a soft
legs (B) to the table top by inserting bolts (D) with metal washers (E) through the pre-drilled holes
in the legs and into the table top. (DO NOT TIGHTEN THE BOLTS COMPLETELY)
Step 2
Attach the leg connector bracket (C) to the table legs by inserting bolts (D) with metal washers (E)
through the pre-drilled holes in the leg connector bracket and into the legs.
Step 3
Using the hex wrench (G), tighten all bolts completely and cover them with plastic bolt
caps (F).
IMPORTANT NOTE: Each bolt should be tightened a few revolutions at a time, alternating
between bolts in a cross corner "X" pattern. This will ensure your table is level by placing equal
pressure
on
all bolt joints. Do not over tighten.
Step 4
Keep touch-up paint (H) for future use for both your table and chairs.
With the help of another person, turn the table in the upright position.
IMPORTANT:
To avoid damage to your table:
- An umbrella base must be used at all times.
- Make sure the umbrella safety ring is installed in the center of the table before you
insert the umbrella pole through the table.
- Remove the umbrella from the table when not in use or in the event of wind, rain, hail, sleet, snow or
any other inclement weather.
- In storing patio furniture, do not stack anything on glass, stone, or marble tabletops.
- Before storing, drain all water that may have accumulated in or around table frame. If not drained properly,
water can cause freeze damage.
- Cover furniture with outdoor furniture covers when not in use.
- For safety reasons, do not sit or stand on the table.
CAPTIVA
Your table is now ready for use.
A
TABLE TOP
B
TABLE LEG
LEG
C
CONNECTOR
BRACKET
surface.
Attach table
D
BOLT (M6x20)
Step 1
Parts List
METAL
E
1
WASHER
PLASTIC
2
F
BOLT CAP
HEX
G
1
WRENCH
H
TOUCH-UP
16
PAINT
Step 2
16
16
1
1
HM-7040T05