Advertisement
Quick Links
Ramp and Platform Bracket Quick Installation Guide
Thank you for purchasing from National Ramp! This quick installation guide will cover how to install the new
Ramp and Platform Bracket. The Ramp and Platform Brackets are used as an added security to prevent ramps
and platforms from disconnecting. It does not take the place of leg supports.
The Ramp and Platform Bracket can be used on Liberty and Breeze systems to secure:
1. Ramps onto Platforms (inside and outside corner)
2. Platforms onto Ramps
Tools Required:
Impact Driver
Phillips Head #2 bit
Instructions:
Please note the following when installing the Ramp and Platform Brackets:
Orientation of the tongue and groove with respect to the orientation of the bracket.
Which holes to use when screwing in bracket.
Improper bracket orientation and/or screw install will result in an ineffective install.
Advertisement
Related Manuals for National ramp Liberty
Summary of Contents for National ramp Liberty
- Page 1 Ramp and Platform Bracket Quick Installation Guide Thank you for purchasing from National Ramp! This quick installation guide will cover how to install the new Ramp and Platform Bracket. The Ramp and Platform Brackets are used as an added security to prevent ramps and platforms from disconnecting.
- Page 2 1. Identify the configuration you are installing the Ramp and Platform Bracket on: o Ramps onto Platforms – outside corner (ramp and platform edges line up) Platform Top image is to show tongue and groove orientation. Platform o Ramps onto Platforms – inside corner Platform o Platforms onto Ramps Platform...
- Page 3 o Ramps onto Ramps Top image is to show tongue and groove orientation. o Platforms onto Platforms Platform Platform 2. (2a) Orient the bracket according to the configuration you are installing to per the diagrams in step 1. (2b) Rotate the bracket approximately 30° (2c &...
- Page 4 3. Fasten bracket onto ramp or platform siderail using #10 (3/16”) x ¾” drilling screw according to the configuration you are installing to per the diagrams in step 1. Note which holes to use! 4. Pull/Push up on tongue side of the ramp or platform to verify install. A successful install will not allow the tongue to disengage from the groove.